On 9/22/26 03:33, Javier Martinez Canillas wrote:
Hello Mario,
On Tue, Sep 8, 2026 at 6:41 AM Mario Limonciello
<[email protected]> wrote:
At Display Next Hackfest 2026 we reviewed progress moving brightness
control into the DRM connector properties.
There is a range LUMINANCE property that will default to 0->0.
Once a driver attaches a backlight it will be updated to 1->max.
If the panel supports the minimum backlight turning off the display
the range can later be updated to 0->max instead of 1->max.
The legacy sysfs interface is synchronized with the DRM connector.
When a compositor using this feature is loaded, sysfs writes are disabled
to prevent legacy tools from going out of sync with the compositor.
I don't think I agree with the direction of this series. The main
issue for me is that if the sysfs interface is disabled, then I don't
understand the value of doing all the hops between the DRM and
backlight subsystems...
The reason for all the hops is that users can switch between compositors
that support this and don't. If you're in a compositor that supports it
that compositor will want to affirm it's in control. If you're in a
compositor without support then you should still have a way to change
things, and that's what the sysfs interface exists for.
IMO when a driver sets the DRIVER_CONNECTOR_LUMINANCE feature and the
client advertise the DRM_CLIENT_CAP_LUMINANCE capability, then the DRM
driver should be in full control of the brightness control and not go
through the backlight subsystem at all.
OK but so let's say I start at 100% brightness. I open up Kwin, I
change the luminance property to 0%. Let's pretend that backlight
subsystem doesn't get updated.
Then I log into Xorg + Xfce. The luminance property should be left at
0%, the brightness subsystem is 100%.
The hardware would be left at 0%. I press the brightness up key (or
call brightnessctl) and I can't change it because backlight subsystem is
100% already.
So it can't be a clean rip and replace; you need to keep both active at
least for a while.
It would be better if the hardware specific logic to do the brightness
control is factored out and used by both the struct
backlight_ops.update_status and the atomic modesetting state check /
commit.
--
Best regards,
Javier Martinez Canillas
Core Platforms
Red Hat
