The display controller of the Ingenic X1600 is not the one ingenic-drm drives: it fetches frames through descriptors and keeps its interface and timings in register blocks of their own. It is the X2000's DPU without the composer. This series adds a binding and a driver for it, then the panel of the HiBy R1, an X1600 audio player: 480x800 parallel RGB, set up over a 3-wire SPI bus.
The driver covers what the R1 uses and what could be tested: parallel RGB panels on a 24-bit bus and one full-screen RGB565 plane. The composer, smart panels and other pixel formats are left out. Two things come from the vendor kernel rather than the manual. A flip also writes SRD_CHAIN_START, which the manual doesn't describe for a running controller; flips without it were not tried. The panel's set-up sequence is the vendor's too: HiBy calls the panel LG35583, its maker and controller are unknown, hence the hiby prefix. Changes in v3: - The compatible is ingenic,x1600-dpu, and the binding and the driver say "display controller" rather than "LCD controller" (Nikolaus). The X2000 and X2600 manuals call this block the DPU, and the X1600 manual does too in its register and clock names. There is no generic ingenic,dpu fallback, as writing-bindings.rst asks for SoC compatibles: an X2000 binding can fall back to the X1600's. The driver keeps its file name; splitting it for the X2000's composer and interfaces belongs with X2000 support. - 2/5: no $nodename and no clock-names; the driver takes its one clock unnamed (Krzysztof). The example's node is display-controller@. - 2/5: there is no IPU in front of this controller (Krzysztof asked on v2, Paul answered): it fetches its own frames, so the output port is its only link. - 4/5: reset-gpios, backlight and port dropped, panel-common has them (Krzysztof). The example's endpoint points at the controller's new label. - Krzysztof's Acked-by on 1/5 and Reviewed-by on 4/5. - Rebased on drm-misc-next after -rc1. Changes in v2, all in 3/5 and all found by the Sashiko review of v1: - Commits wait for flip_done instead of a vblank before the planes are cleaned up. A flip's event waits until the controller reports reading the new descriptor, which can be a frame after the vblank that v1's default commit_tail waited for, so the old framebuffer could be freed while still scanned out. - A CRTC being enabled sends its event from atomic_enable(), once the controller runs; v1 sent it from atomic_flush(), which runs first. - A plane that is not visible is rejected: the controller always scans out a whole frame, so v1 would have read past the end of a small framebuffer placed off-screen. - atomic_disable() returns early when atomic_enable() failed to start the pixel clock, instead of touching an unclocked controller. Tested on a HiBy R1: the fbdev console and a player drawing through fbdev, blanking and unblanking, 60 page flips in 0.97 s at about 61 Hz, and the colour order (RGB order swaps red and blue on this panel). For v2 also: 120 fbdev pans in 1.95 s (one flip per frame, none timing out), three blank/unblank cycles, and a 64x64 framebuffer set on the primary plane just past the right edge through SETPLANE, which v1 accepted and v2 refuses with -EINVAL, while a full-screen one is still accepted. v3 was run on the R1 with its node changed to match: the driver binds to ingenic,x1600-dpu with its clock unnamed, and the player draws. The X1600 has no device tree upstream yet; its support is being posted one subsystem at a time. The R1's backlight uses the X1600 PWM driver posted separately, now at v3: https://lore.kernel.org/r/[email protected] v2: https://lore.kernel.org/r/[email protected] v1: https://lore.kernel.org/r/[email protected] Olivier Louvignes (5): dt-bindings: vendor-prefixes: Add HiBy dt-bindings: display: Add the Ingenic X1600 display controller drm/ingenic: Add a driver for the X1600 display controller dt-bindings: display: panel: Add the HiBy LG35583 drm/panel: Add the HiBy LG35583 .../bindings/display/ingenic,x1600-dpu.yaml | 61 ++ .../bindings/display/panel/hiby,lg35583.yaml | 67 ++ .../devicetree/bindings/vendor-prefixes.yaml | 2 + MAINTAINERS | 12 + drivers/gpu/drm/Makefile | 1 + drivers/gpu/drm/ingenic/Kconfig | 22 + drivers/gpu/drm/ingenic/Makefile | 1 + drivers/gpu/drm/ingenic/ingenic-x1600-drm.c | 744 ++++++++++++++++++ drivers/gpu/drm/panel/Kconfig | 10 + drivers/gpu/drm/panel/Makefile | 1 + drivers/gpu/drm/panel/panel-hiby-lg35583.c | 342 ++++++++ 11 files changed, 1263 insertions(+) create mode 100644 Documentation/devicetree/bindings/display/ingenic,x1600-dpu.yaml create mode 100644 Documentation/devicetree/bindings/display/panel/hiby,lg35583.yaml create mode 100644 drivers/gpu/drm/ingenic/ingenic-x1600-drm.c create mode 100644 drivers/gpu/drm/panel/panel-hiby-lg35583.c base-commit: 41ecf852c07391687beb129e12a231760b5d783f -- 2.39.5
