*** AI-assistance disclosure *** This cover letter and the three patches were prepared with the help of an LLM coding assistant. The author reviewed every line, checked every statement against the tree and his own logs, and takes full responsibility for the content.
This is v4 of the MDSS block-reset series. It supersedes v3 (<[email protected]>) and changes only the last commit message, in response to Dmitry's three questions on v3 2/3 (<awb7bslhrhemsgvu7ubaejvurk6fecotgvqlwtvsoe2benqdgq@tvh2sfjbuzyu>). What changed in v4 ================== v3 3/3 claimed that command-mode panel initialisation "fails with command DMA timeouts and the display comes up as backlight only" because INT2 was left out of reset. That is a causal statement the data does not support: the failure is intermittent (~50%) and we never isolated INT2 as a single variable. v4 drops the claim. The commit now says only what holds: MDSS is an interrupt controller in DT and the DPU takes its IRQ from it, the display clock controller provides both block resets, and firmware can hand over with the block running, so DT describes both of them. The two Reviewed-by tags received on v3 3/3 are carried over; the diff of all three patches is byte-identical to v3 except for that commit message. Answers to the three questions, for the record: - it is an interrupt controller: sm8750.dtsi's mdss node has "interrupt-controller;" and "#interrupt-cells = <1>", and the DPU child uses "interrupts-extended = <&mdss 0>"; dispcc-sm8750 exposes INT2 as MDSS_INT2_GDSC plus DISP_CC_MDSS_CORE_INT2_BCR (0xa000); - side effect: msm_mdss_reset() runs in msm_mdss_probe() (msm_mdss.c:372) before the irq domain is created (:417) and before of_platform_populate() (:537), the group is held for the existing 20 ms and released, and dispcc PLLs/clocks are untouched; - testing: the reset at this position, with core+INT2+RSCC as one bulk group, ran 5/5 cold POR and 2/2 warm resets without a bad boot, against 5 STORM in 9 cold boots when only the core was reset. The exact v4 shape (array API, two resets) has not been booted, and there is no per-reset A/B. 2/3 exists only so the driver honours a DT listing more than one MDSS reset. If you would rather take 3/3 alone, we can drop it; say so and v5 will be 3/3 by itself. Gates for v4 ============ - git am of the three patches onto pristine v7.3-rc7 (24a19b953e) applies cleanly, no fuzz. - checkpatch --strict on the rewritten 0003: 0 errors, 0 warnings, 0 checks. - dt_binding_check and the W=1 build are unchanged from v3 (no code or DT diff in v4). Qianhui Xu (3): dt-bindings: display: msm: mdss-common: describe additional block resets drm/msm/mdss: reset all block resets described in DT arm64: dts: qcom: sm8750: describe all MDSS block resets .../devicetree/bindings/display/msm/mdss-common.yaml | 4 +++- .../devicetree/bindings/display/msm/qcom,sm8750-mdss.yaml | 3 ++- arch/arm64/boot/dts/qcom/sm8750.dtsi | 3 ++- drivers/gpu/drm/msm/msm_mdss.c | 5 ++--- 4 files changed, 9 insertions(+), 6 deletions(-) -- 2.53.0
