Hi Russell,
On 01/06/2014 10:46 AM, Russell King - ARM Linux wrote:
On Mon, Jan 06, 2014 at 06:41:28PM +0100, Philipp Zabel wrote:
Hi Eric,
Am Freitag, den 03.01.2014, 12:14 -0700 schrieb Eric Nelson:
This is an issue we've seen before. The SABRE Lite board has
a voltage divider on the HPD pins and some monitors (esp. DVI
monitors) either don't drive things high enough to assert HPD or
bounce with connect/disconnect.
Yes, I used a DVI monitor.
We've instrumented our 3.0.35 kernels to use the RX_SENSE bits
instead.
Reacting to RX_SENSE0 instead of HPD seems to work.
However, it's non-compliant, because HPD can be lowered and raised by
the sink when it changes its EDID data (eg, because you're connected
through a switch and the routing has been changed.)
So, reacting to RX_SENSE0 instead of HPD has to be a work-around enabled
only for those boards which are broken in this regard.
I understand. We'll need to carry some patches for a while though,
since there are lots of these boards in the wild.
Regards,
Eric
_______________________________________________
devel mailing list
de...@linuxdriverproject.org
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
