Remove the function sca3000_check_status() that is not used anywhere.
This was partially found by using a static code analysis program called
cppcheck.
Signed-off-by: Rickard Strandqvist <rickard_strandqv...@spectrumdigital.se>
---
drivers/staging/iio/accel/sca3000_core.c | 27 ---------------------------
1 file changed, 27 deletions(-)
diff --git a/drivers/staging/iio/accel/sca3000_core.c
b/drivers/staging/iio/accel/sca3000_core.c
index e4e5639..655e34c 100644
--- a/drivers/staging/iio/accel/sca3000_core.c
+++ b/drivers/staging/iio/accel/sca3000_core.c
@@ -223,33 +223,6 @@ error_ret:
return ret;
}
-#ifdef SCA3000_DEBUG
-/**
- * sca3000_check_status() check the status register
- *
- * Only used for debugging purposes
- **/
-static int sca3000_check_status(struct device *dev)
-{
- int ret;
- struct iio_dev *indio_dev = dev_to_iio_dev(dev);
- struct sca3000_state *st = iio_priv(indio_dev);
-
- mutex_lock(&st->lock);
- ret = sca3000_read_data_short(st, SCA3000_REG_ADDR_STATUS, 1);
- if (ret < 0)
- goto error_ret;
- if (st->rx[0] & SCA3000_EEPROM_CS_ERROR)
- dev_err(dev, "eeprom error\n");
- if (st->rx[0] & SCA3000_SPI_FRAME_ERROR)
- dev_err(dev, "Previous SPI Frame was corrupt\n");
-
-error_ret:
- mutex_unlock(&st->lock);
- return ret;
-}
-#endif /* SCA3000_DEBUG */
-
/**
* sca3000_show_rev() - sysfs interface to read the chip revision number
**/
--
1.7.10.4
_______________________________________________
devel mailing list
de...@linuxdriverproject.org
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
