Fix the checkpatch.pl issues about:

WARNING: Block comments use * on subsequent lines
WARNING: Block comments use a trailing */ on a separate line

Signed-off-by: H Hartley Sweeten <hswee...@visionengravers.com>
Cc: Ian Abbott <abbo...@mev.co.uk>
Cc: Greg Kroah-Hartman <gre...@linuxfoundation.org>
---
 drivers/staging/comedi/drivers/ni_660x.c | 17 +++++++++++------
 1 file changed, 11 insertions(+), 6 deletions(-)

diff --git a/drivers/staging/comedi/drivers/ni_660x.c 
b/drivers/staging/comedi/drivers/ni_660x.c
index 232c897..0183497 100644
--- a/drivers/staging/comedi/drivers/ni_660x.c
+++ b/drivers/staging/comedi/drivers/ni_660x.c
@@ -48,8 +48,7 @@ enum ni_660x_constants {
 };
 
 #define NUM_PFI_CHANNELS 40
-/* really there are only up to 3 dma channels, but the register layout allows
-for 4 */
+/* there are only up to 3 dma channels, but the register layout allows for 4 */
 #define MAX_DMA_CHANNEL 4
 
 /* See Register-Level Programmer Manual page 3.1 */
@@ -985,8 +984,11 @@ static int ni_660x_auto_attach(struct comedi_device *dev,
        s->range_table = &range_digital;
        s->insn_bits = ni_660x_dio_insn_bits;
        s->insn_config = ni_660x_dio_insn_config;
-       /*  we use the ioconfig registers to control dio direction, so zero
-       output enables in stc dio control reg */
+
+       /*
+        * We use the ioconfig registers to control dio direction, so zero
+        * output enables in stc dio control reg.
+        */
        ni_660x_write(dev, 0, 0, NI660X_STC_DIO_CONTROL);
 
        devpriv->counter_dev = ni_gpct_device_construct(dev,
@@ -1040,8 +1042,11 @@ static int ni_660x_auto_attach(struct comedi_device *dev,
                                                NI660X_IO_CFG_OUT_SEL_COUNTER);
                ni_660x_select_pfi_output(dev, i, NI660X_IO_CFG_OUT_SEL_HIGH_Z);
        }
-       /* to be safe, set counterswap bits on tio chips after all the counter
-          outputs have been set to high impedance mode */
+
+       /*
+        * To be safe, set counterswap bits on tio chips after all the counter
+        * outputs have been set to high impedance mode.
+        */
        for (i = 0; i < board->n_chips; ++i)
                set_tio_counterswap(dev, i);
 
-- 
2.6.3

_______________________________________________
devel mailing list
de...@linuxdriverproject.org
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel

Reply via email to