When updating the in_illuminance_calibscale and
in_illuminance_integration_time sysfs attributes, these values were not
actually written to the chip. The chip would continue to use the old
parameters. Extracted out tsl2583_set_als_gain() and
tsl2583_set_als_time() functions that are now called when these sysfs
attributes are updated. The chip initialization now calls these these
new functions.
Rename taos_chip_on() to tsl2583_chip_init() since it is now only called
during device probing and when the power management code wakes the
device back up. tsl2583_chip_init() was refactored to use the new
functions mentioned above.
Previously, the current chip state was represented as a tristate
(working, suspended, and unknown). The unknown state was not used. The
chip state is now represented with a single boolean value (suspended).
Signed-off-by: Brian Masney <masn...@onstation.org>
---
drivers/staging/iio/light/tsl2583.c | 172 ++++++++++++++++--------------------
1 file changed, 78 insertions(+), 94 deletions(-)
diff --git a/drivers/staging/iio/light/tsl2583.c
b/drivers/staging/iio/light/tsl2583.c
index 7eab17f..1ff90b3 100644
--- a/drivers/staging/iio/light/tsl2583.c
+++ b/drivers/staging/iio/light/tsl2583.c
@@ -48,6 +48,8 @@
#define TSL258X_TMR_LO 0x18
#define TSL258X_TMR_HI 0x19
+#define TSL2583_INTERRUPT_DISABLED 0x00
+
/* tsl2583 cmd reg masks */
#define TSL258X_CMD_REG 0x80
#define TSL258X_CMD_SPL_FN 0x60
@@ -55,6 +57,7 @@
/* tsl2583 cntrl reg masks */
#define TSL258X_CNTL_ADC_ENBL 0x02
+#define TSL258X_CNTL_PWR_OFF 0x00
#define TSL258X_CNTL_PWR_ON 0x01
/* tsl2583 status reg masks */
@@ -67,12 +70,6 @@
#define TSL2583_CHIP_ID 0x90
#define TSL2583_CHIP_ID_MASK 0xf0
-enum {
- TSL258X_CHIP_UNKNOWN = 0,
- TSL258X_CHIP_WORKING = 1,
- TSL258X_CHIP_SUSPENDED = 2
-};
-
/* Per-device data */
struct taos_als_info {
u16 als_ch0;
@@ -94,19 +91,9 @@ struct tsl2583_chip {
struct taos_settings taos_settings;
int als_time_scale;
int als_saturation;
- int taos_chip_status;
- u8 taos_config[8];
+ bool suspended;
};
-/*
- * Initial values for device - this values can/will be changed by driver.
- * and applications as needed.
- * These values are dynamic.
- */
-static const u8 taos_config[8] = {
- 0x00, 0xee, 0x00, 0x03, 0x00, 0xFF, 0xFF, 0x00
-}; /* cntrl atime intC Athl0 Athl1 Athh0 Athh1 gain */
-
struct taos_lux {
unsigned int ratio;
unsigned int ch0;
@@ -188,13 +175,6 @@ static int taos_get_lux(struct iio_dev *indio_dev)
u32 ch0lux = 0;
u32 ch1lux = 0;
- if (chip->taos_chip_status != TSL258X_CHIP_WORKING) {
- /* device is not enabled */
- dev_err(&chip->client->dev, "taos_get_lux device is not
enabled\n");
- ret = -EBUSY;
- goto done;
- }
-
ret = i2c_smbus_read_byte_data(chip->client, TSL258X_CMD_REG);
if (ret < 0) {
dev_err(&chip->client->dev, "taos_get_lux failed to read
CMD_REG\n");
@@ -362,26 +342,10 @@ static int taos_als_calibrate(struct iio_dev *indio_dev)
return (int)gain_trim_val;
}
-/*
- * Turn the device on.
- * Configuration must be set before calling this function.
- */
-static int taos_chip_on(struct iio_dev *indio_dev)
+static int tsl2583_set_als_time(struct tsl2583_chip *chip)
{
- int i;
- int ret;
- u8 *uP;
- u8 utmp;
- int als_count;
- int als_time;
- struct tsl2583_chip *chip = iio_priv(indio_dev);
-
- /* and make sure we're not already on */
- if (chip->taos_chip_status == TSL258X_CHIP_WORKING) {
- /* if forcing a register update - turn off, then on */
- dev_info(&chip->client->dev, "device is already enabled\n");
- return -EINVAL;
- }
+ int als_count, als_time, ret;
+ u8 val;
/* determine als integration register */
als_count = (chip->taos_settings.als_time * 100 + 135) / 270;
@@ -390,60 +354,82 @@ static int taos_chip_on(struct iio_dev *indio_dev)
/* convert back to time (encompasses overrides) */
als_time = (als_count * 27 + 5) / 10;
- chip->taos_config[TSL258X_ALS_TIME] = 256 - als_count;
- /* Set the gain based on taos_settings struct */
- chip->taos_config[TSL258X_GAIN] = chip->taos_settings.als_gain;
+ val = 256 - als_count;
+ ret = i2c_smbus_write_byte_data(chip->client,
+ TSL258X_CMD_REG | TSL258X_ALS_TIME,
+ val);
+ if (ret < 0) {
+ dev_err(&chip->client->dev,
+ "%s failed to set the als time to %d\n",
+ __func__, val);
+ return ret;
+ }
/* set chip struct re scaling and saturation */
chip->als_saturation = als_count * 922; /* 90% of full scale */
chip->als_time_scale = (als_time + 25) / 50;
- /* Power on the device; ADC off. */
- chip->taos_config[TSL258X_CNTRL] = TSL258X_CNTL_PWR_ON;
+ return ret;
+}
- /*
- * Use the following shadow copy for our delay before enabling ADC.
- * Write all the registers.
- */
- for (i = 0, uP = chip->taos_config; i < TSL258X_REG_MAX; i++) {
- ret = i2c_smbus_write_byte_data(chip->client,
- TSL258X_CMD_REG + i,
- *uP++);
- if (ret < 0) {
- dev_err(&chip->client->dev,
- "taos_chip_on failed on reg %d.\n", i);
- return ret;
- }
- }
+static int tsl2583_set_als_gain(struct tsl2583_chip *chip)
+{
+ int ret;
- usleep_range(3000, 3500);
- /*
- * NOW enable the ADC
- * initialize the desired mode of operation
- */
- utmp = TSL258X_CNTL_PWR_ON | TSL258X_CNTL_ADC_ENBL;
ret = i2c_smbus_write_byte_data(chip->client,
- TSL258X_CMD_REG | TSL258X_CNTRL,
- utmp);
- if (ret < 0) {
- dev_err(&chip->client->dev, "taos_chip_on failed on 2nd CTRL
reg.\n");
- return ret;
- }
- chip->taos_chip_status = TSL258X_CHIP_WORKING;
+ TSL258X_CMD_REG | TSL258X_GAIN,
+ chip->taos_settings.als_gain);
+ if (ret < 0)
+ dev_err(&chip->client->dev, "%s failed to set the gain to %d\n",
+ __func__, chip->taos_settings.als_gain);
return ret;
}
-static int taos_chip_off(struct iio_dev *indio_dev)
+static int tsl2583_set_power_state(struct tsl2583_chip *chip, u8 state)
{
- struct tsl2583_chip *chip = iio_priv(indio_dev);
+ int ret;
+
+ ret = i2c_smbus_write_byte_data(chip->client,
+ TSL258X_CMD_REG | TSL258X_CNTRL, state);
+ if (ret < 0)
+ dev_err(&chip->client->dev, "%s failed to set the power state
to %d\n",
+ __func__, state);
- /* turn device off */
- chip->taos_chip_status = TSL258X_CHIP_SUSPENDED;
- return i2c_smbus_write_byte_data(chip->client,
- TSL258X_CMD_REG | TSL258X_CNTRL,
- 0x00);
+ return ret;
+}
+
+static int tsl2583_chip_init(struct tsl2583_chip *chip)
+{
+ int ret;
+
+ ret = tsl2583_set_power_state(chip, TSL258X_CNTL_PWR_ON);
+ if (ret < 0)
+ return ret;
+
+ ret = i2c_smbus_write_byte_data(chip->client,
+ TSL258X_CMD_REG | TSL258X_INTERRUPT,
+ TSL2583_INTERRUPT_DISABLED);
+ if (ret < 0) {
+ dev_err(&chip->client->dev, "%s failed to disable interrupts\n",
+ __func__);
+ return ret;
+ }
+
+ ret = tsl2583_set_als_time(chip);
+ if (ret < 0)
+ return ret;
+
+ ret = tsl2583_set_als_gain(chip);
+ if (ret < 0)
+ return ret;
+
+ usleep_range(3000, 3500);
+
+ /* Enable the ADC and initialize the desired mode of operation */
+ return tsl2583_set_power_state(chip, TSL258X_CNTL_PWR_ON |
+ TSL258X_CNTL_ADC_ENBL);
}
/* Sysfs Interface Functions */
@@ -616,7 +602,7 @@ static int tsl2583_read_raw(struct iio_dev *indio_dev,
mutex_lock(&chip->als_mutex);
- if (chip->taos_chip_status != TSL258X_CHIP_WORKING) {
+ if (chip->suspended) {
ret = -EBUSY;
goto read_done;
}
@@ -693,7 +679,7 @@ static int tsl2583_write_raw(struct iio_dev *indio_dev,
mutex_lock(&chip->als_mutex);
- if (chip->taos_chip_status != TSL258X_CHIP_WORKING) {
+ if (chip->suspended) {
ret = -EBUSY;
goto write_done;
}
@@ -716,13 +702,14 @@ static int tsl2583_write_raw(struct iio_dev *indio_dev,
break;
}
}
+ ret = tsl2583_set_als_gain(chip);
}
break;
case IIO_CHAN_INFO_INT_TIME:
if (chan->type == IIO_LIGHT && !val && val2 >= 50 &&
val2 <= 650 && !(val2 % 50)) {
chip->taos_settings.als_time = val2;
- ret = 0;
+ ret = tsl2583_set_als_time(chip);
}
break;
default:
@@ -767,8 +754,7 @@ static int taos_probe(struct i2c_client *clientp,
i2c_set_clientdata(clientp, indio_dev);
mutex_init(&chip->als_mutex);
- chip->taos_chip_status = TSL258X_CHIP_UNKNOWN;
- memcpy(chip->taos_config, taos_config, sizeof(chip->taos_config));
+ chip->suspended = false;
ret = i2c_smbus_read_byte_data(clientp,
TSL258X_CMD_REG | TSL258X_CHIPID);
@@ -808,7 +794,7 @@ static int taos_probe(struct i2c_client *clientp,
taos_defaults(chip);
/* Make sure the chip is on */
- ret = taos_chip_on(indio_dev);
+ ret = tsl2583_chip_init(chip);
if (ret < 0)
return ret;
@@ -825,10 +811,8 @@ static int taos_suspend(struct device *dev)
mutex_lock(&chip->als_mutex);
- if (chip->taos_chip_status == TSL258X_CHIP_WORKING) {
- ret = taos_chip_off(indio_dev);
- chip->taos_chip_status = TSL258X_CHIP_SUSPENDED;
- }
+ chip->suspended = true;
+ ret = tsl2583_set_power_state(chip, TSL258X_CNTL_PWR_OFF);
mutex_unlock(&chip->als_mutex);
return ret;
@@ -842,8 +826,8 @@ static int taos_resume(struct device *dev)
mutex_lock(&chip->als_mutex);
- if (chip->taos_chip_status == TSL258X_CHIP_SUSPENDED)
- ret = taos_chip_on(indio_dev);
+ chip->suspended = false;
+ ret = tsl2583_chip_init(chip);
mutex_unlock(&chip->als_mutex);
return ret;
--
2.5.5
_______________________________________________
devel mailing list
de...@linuxdriverproject.org
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
