This is a step toward eliminating the RT_TRACE macros. Those calls that
have DBG_EMERG as the level are always logged, and they represent error
conditions, thus they are replaced with pr_err().
Signed-off-by: Larry Finger <larry.fin...@lwfinger.net>
Cc: Ping-Ke Shih <pks...@realtek.com>
---
V2 - eliminate some files that should not have been sent.
---
.../wireless/realtek/rtlwifi/rtl8192c/fw_common.c | 33 ++++++----------------
.../wireless/realtek/rtlwifi/rtl8192c/phy_common.c | 13 ++++-----
2 files changed, 15 insertions(+), 31 deletions(-)
diff --git a/drivers/net/wireless/realtek/rtlwifi/rtl8192c/fw_common.c
b/drivers/net/wireless/realtek/rtlwifi/rtl8192c/fw_common.c
index 4a49e66..e739e56 100644
--- a/drivers/net/wireless/realtek/rtlwifi/rtl8192c/fw_common.c
+++ b/drivers/net/wireless/realtek/rtlwifi/rtl8192c/fw_common.c
@@ -145,10 +145,8 @@ static void _rtl92c_write_fw(struct ieee80211_hw *hw,
pageNums = size / FW_8192C_PAGE_SIZE;
remainsize = size % FW_8192C_PAGE_SIZE;
- if (pageNums > 4) {
- RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
- "Page numbers should not greater then 4\n");
- }
+ if (pageNums > 4)
+ pr_err("Page numbers should not greater then 4\n");
for (page = 0; page < pageNums; page++) {
offset = page * FW_8192C_PAGE_SIZE;
@@ -180,15 +178,10 @@ static int _rtl92c_fw_free_to_go(struct ieee80211_hw *hw)
(!(value32 & FWDL_ChkSum_rpt)));
if (counter >= FW_8192C_POLLING_TIMEOUT_COUNT) {
- RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
- "chksum report faill ! REG_MCUFWDL:0x%08x .\n",
- value32);
+ pr_err("chksum report fail! REG_MCUFWDL:0x%08x .\n",
+ value32);
goto exit;
}
-
- RT_TRACE(rtlpriv, COMP_FW, DBG_TRACE,
- "Checksum report OK ! REG_MCUFWDL:0x%08x .\n", value32);
-
value32 = rtl_read_dword(rtlpriv, REG_MCUFWDL);
value32 |= MCUFWDL_RDY;
value32 &= ~WINTINI_RDY;
@@ -198,20 +191,15 @@ static int _rtl92c_fw_free_to_go(struct ieee80211_hw *hw)
do {
value32 = rtl_read_dword(rtlpriv, REG_MCUFWDL);
- if (value32 & WINTINI_RDY) {
- RT_TRACE(rtlpriv, COMP_FW, DBG_TRACE,
- "Polling FW ready success!! REG_MCUFWDL:0x%08x
.\n",
- value32);
- err = 0;
- goto exit;
- }
+ if (value32 & WINTINI_RDY)
+ return 0;
mdelay(FW_8192C_POLLING_DELAY);
} while (counter++ < FW_8192C_POLLING_TIMEOUT_COUNT);
- RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
- "Polling FW ready fail!! REG_MCUFWDL:0x%08x .\n", value32);
+ pr_err("Polling FW ready fail! REG_MCUFWDL:0x%08x.\n",
+ value32);
exit:
return err;
@@ -251,8 +238,7 @@ int rtl92c_download_fw(struct ieee80211_hw *hw)
err = _rtl92c_fw_free_to_go(hw);
if (err) {
- RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
- "Firmware is not ready to run!\n");
+ pr_err("Firmware is not ready to run!\n");
} else {
RT_TRACE(rtlpriv, COMP_FW, DBG_TRACE,
"Firmware is ready to run!\n");
@@ -327,8 +313,7 @@ static void _rtl92c_fill_h2c_command(struct ieee80211_hw
*hw,
while (!bwrite_sucess) {
wait_writeh2c_limmit--;
if (wait_writeh2c_limmit == 0) {
- RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
- "Write H2C fail because no trigger for FW
INT!\n");
+ pr_err("Write H2C fail because no trigger for FW
INT!\n");
break;
}
diff --git a/drivers/net/wireless/realtek/rtlwifi/rtl8192c/phy_common.c
b/drivers/net/wireless/realtek/rtlwifi/rtl8192c/phy_common.c
index 30c2d12..5f8fa4a 100644
--- a/drivers/net/wireless/realtek/rtlwifi/rtl8192c/phy_common.c
+++ b/drivers/net/wireless/realtek/rtlwifi/rtl8192c/phy_common.c
@@ -104,7 +104,7 @@ u32 _rtl92c_phy_rf_serial_read(struct ieee80211_hw *hw,
offset &= 0x3f;
newoffset = offset;
if (RT_CANNOT_IO(hw)) {
- RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, "return all one\n");
+ pr_err("return all one\n");
return 0xFFFFFFFF;
}
tmplong = rtl_get_bbreg(hw, RFPGA0_XA_HSSIPARAMETER2, MASKDWORD);
@@ -152,7 +152,7 @@ void _rtl92c_phy_rf_serial_write(struct ieee80211_hw *hw,
struct bb_reg_def *pphyreg = &rtlphy->phyreg_def[rfpath];
if (RT_CANNOT_IO(hw)) {
- RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, "stop\n");
+ pr_err("stop\n");
return;
}
offset &= 0x3f;
@@ -209,7 +209,7 @@ bool _rtl92c_phy_bb8192c_config_parafile(struct
ieee80211_hw *hw)
rtstatus = rtlpriv->cfg->ops->config_bb_with_headerfile(hw,
BASEBAND_CONFIG_PHY_REG);
if (!rtstatus) {
- RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, "Write BB Reg Fail!!\n");
+ pr_err("Write BB Reg Fail!!\n");
return false;
}
if (rtlphy->rf_type == RF_1T2R) {
@@ -222,13 +222,13 @@ bool _rtl92c_phy_bb8192c_config_parafile(struct
ieee80211_hw *hw)
BASEBAND_CONFIG_PHY_REG);
}
if (!rtstatus) {
- RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, "BB_PG Reg Fail!!\n");
+ pr_err("BB_PG Reg Fail!!\n");
return false;
}
rtstatus = rtlpriv->cfg->ops->config_bb_with_headerfile(hw,
BASEBAND_CONFIG_AGC_TAB);
if (!rtstatus) {
- RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, "AGC Table Fail\n");
+ pr_err("AGC Table Fail\n");
return false;
}
rtlphy->cck_high_power =
@@ -860,8 +860,8 @@ bool _rtl92c_phy_sw_chnl_step_by_step(struct ieee80211_hw
*hw,
currentcmd = &postcommoncmd[*step];
break;
default:
- RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
- "Invalid 'stage' = %d, Check it!\n", *stage);
+ pr_err("Invalid 'stage' = %d, Check it!\n",
+ *stage);
return true;
}
--
2.10.2
_______________________________________________
devel mailing list
de...@linuxdriverproject.org
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
