I have a used Duet; trying to set it up on my network. I have re-set the controller to "Factory Default" and reset the Receiver (hold button until fast red blink... then it goes to slow red blink)
I do NOT see "squeezebox xyz" where xyz is the last part of the Mac address in the Networks list on the controller. I see plenty of WiFi networks but no "squeezebox..." anything. So, I plugged the Duet Receiver into my LAN using Ethernet. I can see it has acquired an IP address via DHCP from my router, so I know it's on the LAN. I followed the instructions from http://support.logitech.com/en_sg/article/11914 "Connecting Squeezebox Duet in Hybrid Mode" and it says "After your Controller successfully connects to your network, select ‘Set up Receiver’ and click the center button." <= there is no option anywhere on the Controller labelled 'Set Up Receiver' after my controller successfully connects to my WLAN. What do I do??? How do I configure the receiver? I tried connecting the Receiver via Ethernet to a PC and using the UDAP Perl stuff, but after installing all the modules that the error messages complained about I got to an error message that complained that Term::Shell was not found, and no matter what I did I could not find a Term::Shell that I could use, and trying to install it from cpan resulted in errors complaining abut the compiler etc. After 3 hours screwing around trying to get UDAP to work I gave up. Am I screwed? Is there any WINDOWS utility that I can use? I've given up trying to use UDAP.... ------------------------------------------------------------------------ milosz's Profile: http://forums.slimdevices.com/member.php?userid=11057 View this thread: http://forums.slimdevices.com/showthread.php?t=107277 _______________________________________________ Duet mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/duet
