Try clicking two ( might be three ) times on the open button.Then everything shows up again as it was when reduced.. Wanted or not, guess its not a big problem.
Good luck and 73's Jos on4kj ----- Original Message ----- From: "Richard L. King" <[EMAIL PROTECTED]> To: "Rick Stoneking" <[EMAIL PROTECTED]>; <dx4win@mailman.qth.net> Sent: Thursday, July 10, 2003 6:36 PM Subject: Re: [Dx4win] V6.02 question > This happens to me once in a while. I have been unable to figure out if > there is a specific sequence that causes it happen since I can never > recreate the problem when I want to. > > But it does happen. It isn't a problem, but is annoying when it occurs. > > I am running DX4WIN 6.02 and and Win 98SE. > > 73, Richard - K5NA > > At 09:58 7/9/03 -0400, Rick Stoneking wrote: > >All, > > > >I have noticed that since I upgraded to V6.02 that there is an annoying > >behavior that did not happen in the 5.x versions. The problem is that > >when I have DX4WIN open and I then open/switch to another window (web > >browser for example) when I click the DX4WIN button on the start/programs > >bar at the bottom of the screen to switch back to DX4WIN, only the window > >that was selected/active in DX4WIN pops up. For example, if the QSO entry > >window was active when I switched to my web browser then that will be the > >only window that pops up on top of the browser when I click the DX4WIN > >button at the bottom of the screen. > > > >Has anyone else seen this? Is there a way to change it? > > > >Thanks, > >Rick > >W2RDS > > > >_______________________________________________ > >Dx4win mailing list > >Dx4win@mailman.qth.net > >http://mailman.qth.net/mailman/listinfo/dx4win > > [EMAIL PROTECTED] > > > _______________________________________________ > Dx4win mailing list > Dx4win@mailman.qth.net > http://mailman.qth.net/mailman/listinfo/dx4win >