I am running 6.03 with a Mark 5 as radio 1 and a Kenwood as radio 2. For the Mark 5, the polling rate (as reflected by the CAT light on the front panel) is regular but very slow (about once a second). Checking my settings, I found that the polling rate is set at 500 ms. I changed it to 100 ms and, to my surprise, there was no change in the frequency at which the CAT light flashes. I don't know if this is related to Timon's problem or not.
73, Pete N4ZR At 08:26 AM 6/22/2005, Timon PA1T wrote: >Gentelmen, > >I am running a ft1000mp m5 as radio 1 and a ft1000mp as radio 2. >Using micraham bandecoders and doubel ten switch box. > >When I run n1mm contest software at both radio's the cat led is blinking all >the time in a normal rithem. > >When I run dx4win and run the mark 5 as radio 1 the cat is blinking 6 times >ans the it stops for about 6 seconds. The second radios cat is blinking ok. >When I make radio 2 the 1000 mp radio 1 the cath is blinking one time waits >four seconds an blinks again. > >I think that if a radio is selected that cat has to blink in a normal rithem >as it does at the n1mm software. >Maybe something for a next update. >I am runnig 6.04 > >73 Timon pa1t > >Email [EMAIL PROTECTED] >Home page www.pa1t.com > > >_______________________________________________ >Dx4win mailing list >[email protected] >http://mailman.qth.net/mailman/listinfo/dx4win
