Hi all I am trying to upgrade and am experiencing some problems. I am upgrading from 6.03 to 6.04. The problem I am experiencing is rig control. I have two rigs. My problem is I cannot communicate with rig 2. Yes, I have looked at Rig in Preference to see what, if anything has changed. The default baud rate was 9600 and needed to be reset to 4800. Do I need to change it in Rig window and/or in Write.ini? I am following the suggestions Jim, AD1C, recommends. I do not find the .RIG file I need to copy from 6.03 save and place in 6.04 save. And, of course this is where I am having problems. Thanks in advance for helping 73's
Michael WG0M From [EMAIL PROTECTED] Thu Mar 31 11:15:15 2005 From: [EMAIL PROTECTED] (Jim Reisert AD1C) Date: Thu Mar 31 11:16:26 2005 Subject: [Dx4win] Re: Example of collapsed DX4WIN.CTY release notes In-Reply-To: 6667 Message-ID: <[EMAIL PROTECTED]> --- Jim Reisert AD1C <[EMAIL PROTECTED]> wrote: > I have put up an example of collapsing the DX4WIN release notes: > > http://www.ad1c.us/dx4win/history_java.htm > > Just click on one of the headings to toggle the information below it: > > Prefix Mappings > Callsign Exceptions > QSL Managers (changes only) > > I have tested this in both Internet Explorer and Firefox. I've finished making the changes. All but the latest release notes (17) are "rolled up". Do not bookmark this page, it's only temporary. Unless there are strong objections, I will make this the default revision history page going forward. 73 - Jim AD1C -- Jim Reisert AD1C, 7 Charlemont Court, North Chelmsford, MA 01863 USA +978-251-9933, <[EMAIL PROTECTED]>, http://www.ad1c.us
