I did that; it makes sense. But there is no difference. I saved changes, created new .ini file, exited DX4Win, restarted the program, opened the file, and the country count is the same; there are duplicates.
Larry Jim Reisert AD1C wrote: > At 06:52 AM 4/7/2006, Larry M. Leitch wrote: > >> What is the easiest (and best) way to get a list of QSOs (without >> duplicate countries) to be submitted for DXCC? When I go to >> Reports...DXCC...Submission I get multiple entries for some countries >> because there have been QSOs on different bands/modes with that country. > > > Larry, in Preferences, click on the DXCC tab. Under Awards, make sure > that only Mixed is selected, and Band and Mode are NOT selected. Then > do the DXCC submission again. > > 73 - Jim AD1C > > From [EMAIL PROTECTED] Fri Apr 7 10:07:40 2006 From: [EMAIL PROTECTED] (Jim Reisert AD1C) Date: Fri Apr 7 10:07:59 2006 Subject: [Dx4win] DXCC Submission List, No Duplicate Countries In-Reply-To: <[EMAIL PROTECTED]> Message-ID: <[EMAIL PROTECTED]> --- "Larry M. Leitch" <[EMAIL PROTECTED]> wrote: > I did that; it makes sense. But there is no difference. I saved changes, > created new .ini file, exited DX4Win, restarted the program, opened the > file, and the country count is the same; there are duplicates. Once the submission flags are set, they will stay set. You have to clear them all, the re-run the submission report. - Jim -- Jim Reisert AD1C, 7 Charlemont Court, North Chelmsford, MA 01863 USA +978-251-9933, <[EMAIL PROTECTED]>, http://www.ad1c.us From [EMAIL PROTECTED] Fri Apr 7 13:12:37 2006 From: [EMAIL PROTECTED] (Art - W6KY) Date: Fri Apr 7 13:13:00 2006 Subject: [Dx4win] page breaks in labels In-Reply-To: <[EMAIL PROTECTED]> Message-ID: <[EMAIL PROTECTED]> Dale, I think most people here don't even know what a 'tractor feed' printer is with continuous labels. I used to have an Epson and one of the switches was 'ignore page breaks'... I don't know if DX4WIN has a selection for continuous labels. It is trying to do a page eject after xx labels. Check you switches again and maybe someone has the answer for this type of label in DX4WIN... Gee! I'm no help! 73, Art W6KY --- Dale <[EMAIL PROTECTED]> wrote: > I have licensed version of DX4WIN version 6.02. > > Just completed entering numerous contacts and trying > to print the labels on tractor-feed printer...It is > a relatively new printer, and I have carefully > checked and double-checked the tiny DIP-switches to > see that they are correct. > > There is something in the program that is sending > page breaks after every 4 labels (each page break > caused the printer to skip about 20 labels) . > > How can I eliminate the unwanted page breaks...? > > > Thanks > > Dale - N3BNA, V26A, XE1ISE, 5X4DEL, ZP6T(op), ET3PMW > (op), LZ/N3BNA, LU/N3BNA,S5/N3BNA, ZP0Z(op), TI5N > (op), 9Y4W, ZP6/N3BNA, > _______________________________________________ > Dx4win mailing list > [email protected] > http://mailman.qth.net/mailman/listinfo/dx4win >
