Yes Jim they did for my IC-7800 -----Oorspronkelijk bericht----- Van: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Namens Jim Reisert AD1C Verzonden: Wednesday, August 15, 2007 4:38 PM Aan: Alan Braun; Thomas Herrmann CC: [email protected] Onderwerp: Re: [Dx4win] Fwd: FT-2000 users... new firmware
At 06:25 AM 8/15/2007, Alan Braun wrote: >Does ICOM ever put out updates like this? I have an IC-756proIII and >was wondering. Never heard of such a thing. 73 - Jim AD1C -- Jim Reisert AD1C/0, <[EMAIL PROTECTED]>, http://www.ad1c.us _______________________________________________ Dx4win mailing list [email protected] http://mailman.qth.net/mailman/listinfo/dx4win From [EMAIL PROTECTED] Wed Aug 15 20:43:40 2007 From: [EMAIL PROTECTED] (Mack Johnson, N4SS) Date: Wed Aug 15 20:54:34 2007 Subject: [Dx4win] FT847 In-Reply-To: <[EMAIL PROTECTED]> References: <[EMAIL PROTECTED]> <[EMAIL PROTECTED]> Message-ID: <[EMAIL PROTECTED]> I used the FT-847 with DX4WIN for a while but built the RS232 cable myself. It only uses 3 wires, pins 2, 3, and 5. Use two 9 pin FEMALE RS232 connectors (radio shack) and a 4 foot length of 2 conductor shielded cable that I removed from an old pair of cheap stereo headsets.. Connect like this; Radio Computer 2 --------------> 3 3 --------------> 2 5 --------------> 5 (Ground Shield) I setup the DX4WIN rig file on com 1, 4800 baud, 8 data bits, no parity, and 1 stop bit. I do remember seeing the information about Prod. run 5 and "think" it refers to the radio production run versus eprom software. I paid no attention to it. Naturally, the FT-2000 I now own uses a different RS232 pin configuration. Yep, nothing stays the same, HI. Hope this helps a bit. Best 73's and DX, Mack N4SS ----- Original Message ----- From: "Isidro Acosta Hern?ndez" <[EMAIL PROTECTED]> To: "John Kjos" <[EMAIL PROTECTED]>; <[email protected]> Sent: Tuesday, August 14, 2007 4:48 PM Subject: Re: [Dx4win] FT847 > Hi John and the Reflector... > >> What does (Prod. run 5 or modified) mean for the FT847 in DX4WIN. I have >> the Null Modem cable but doesn't work in DX4WIN. My Serial Number is: >> OK440154 on the back of the radio. Do I need some modification done? > > Are you sure you need a null-modem cable? I use the Yaesu interface cable > CT-62 with my FT-897D and it works fine with DX4WIN, except the split > function. > > > 73 de Isidro, EA8NQ > E-mail: [EMAIL PROTECTED] (remove the _ ) > > --------------------------------------- > Visit the EA8NQ's DX Page (in Spanish): > (new url) http://ea8nq.ure.es/ > --------------------------------------- > > _______________________________________________ > Dx4win mailing list > [email protected] > http://mailman.qth.net/mailman/listinfo/dx4win
