Hi Guys,
Here is something I just stumbled across with the newest version of DX4Win:
My Kenwood TS-950SDX has always been perfect when being controlled by
all previous versions of DX4Win (after I upgraded the bios in the
radio). With the latest version I have run into an issue when
listening to a memory and clicking on a spot, the radio will change to
the mode of the spot and stay on the memory frequency and indicate it
is still in memory mode. If I switch to the VFO, the frequency is set
to the spot correctly. The radio no longer switches to the VFO
automatically.
I launched the previous version of DX4Win (7.02.15) and it again works
perfectly, switching to the VFO as it should.
Next I tried my TS-690SAT (on radio 2 connection) and found exactly
the same thing happened. So it appears something has changed in the
control of the radio.
I then copied the driver from the older version (after renaming the
driver in the new version and shut down and restarted DX4Win. This
did not resolve the problem. So it appears the issue is not the
driver itself.
Anyone else notice this???
Paul?? Thoughts??
73, Tom W1TJL
--
Tom LeClerc, Amateur Radio Station W1TJL
(past calls WB1CBY, /VE8,XL8,VO1)
LeClerc Consulting
email: [EMAIL PROTECTED]
PC/Network Consulting
From [EMAIL PROTECTED] Sat May 12 20:08:06 2007
From: [EMAIL PROTECTED] (Frank Kisselbach)
Date: Sat May 12 20:17:07 2007
Subject: [Dx4win] Issue with Kenwood in 7.03.16
In-Reply-To: <[EMAIL PROTECTED]>
Message-ID: <[EMAIL PROTECTED]>
Exact same problem with the TS-570
Frank
W7PAQ
