Larry, is it the real-time format or the SH/DX format that's broken? If you connect to a CC Cluster node (like N5IN-2 or VE7CC-1), it should work.
73 - Jim AD1C --- "Larry Gauthier (K8UT)" <[EMAIL PROTECTED]> wrote: > With my PC setup, I pass ARUser spots to my logging program's DX spot window > via a local TCP link. I have recently noticed that all spots sent from > ARUser are shown as happening today (today's date) in DX4Win, even though > they may be displayed in ARUser as happening on a previous date. Obviously, > this bug creates a useless spot list in DX4Win for stations that have not > been on the air for 24 or 48 (or even more) hours! > > I have not been able to determine where the problem resides - is this an > ARUser issue or a DX4Win issue? Actually, I'm not even certain that it's a > real problem at all... perhaps just pilot error on my part. If anyone else > had similar problems I'd like to hear about it and how you fixed it. > > Thanks in advance, > > -larry > K8UT -- Jim Reisert AD1C/?, <[EMAIL PROTECTED]>, http://www.ad1c.us From [EMAIL PROTECTED] Thu Mar 20 19:08:21 2008 From: [EMAIL PROTECTED] (Brad Nowak) Date: Thu Mar 20 19:14:31 2008 Subject: [Dx4win] DX4WIN problems controlling radio and rotor References: <[EMAIL PROTECTED]> Message-ID: <[EMAIL PROTECTED]> I have two questions for the experts here on the list. I'm new to DX4Win so my questions may seem basic to some. 1. Is anyone on the list using an Alfa-Spid rotor controlled by DX4Win? If so, what settings are being used? Seems I can't get this to function at all. No response from the controller at all. I've tried the settings for Orion, Yaesu and DCU-1 with no luck. Incidently, I am using a "real" com port (com1) and not using a USB to serial convertor. I have also adjusted com port settings in Windows hardware settings to match settings for above rotor controllers and I believe the controller is fine as it works with another logging program using same port just swell. 2. Is anyone controlling a SteppIR antenna using the SteppIR Y-cable with a 1000MP? The radio control seems to work fine but the antenna controller appears to "read" the wrong frequency from time-to-time and start to adjust to a wierd frequency like 35.055Mhz then "reads" the correct operating freq. on the next polling cycle and goes back to the original radio freq. (14.195Mhz e.g.). I've tried most if not all combinations of DTR, RTS and polling settings with no luck. Again, as above no USB (com2) and I don't suspect the SteppIR controller as it works perfectly using another logging program. If anyone has had either of these problems and knows a solution, I would be much obliged. Thanks, Brad - N8SNM
