Hi, I'm sorted now, I had too many things configured in Dx4Win on com1... because I hadn't configured anything other than the CAT interface it didn't dawn on me some of the other devices were sharing the same port. I had the same problem with Winkey but once I checked the options I realised I had two devices sharing that port as well. I've now got a working CAT and Winkey interface :-)
Thanks to everyone for taking the time to reply Regards David -----Original Message----- From: Les Kalmus [mailto:[EMAIL PROTECTED] Sent: 02 June 2008 16:05 To: [EMAIL PROTECTED] Cc: [email protected] Subject: Re: [Dx4win] Ft1000D David, I have the same settings. Also, DTR and RTS both high. Polling 5000 ms. Works fine under 7.03.16. Used to work fine under earlier versions as far as I remember. I am going through a MicroHam MicroKeyer but that shouldn't make a difference. Les W2LK David Warr wrote: > Hello, > > I'm trying to get the CAT interface working with a FT1000D. It works fine > under Writelog so I know the interface, comm port and radio is working but > when I try to get it to work under Dx4Win the interface times out. I can see > the rig being polled but that's all. > > I've selected Ft1000, 4800 Bd and the address is set at 00 (is that correct) > > I'm using ver 7.02.15 > > Any ideas? > > Regards > > David > > > _______________________________________________ > Dx4win mailing list > [email protected] > http://mailman.qth.net/mailman/listinfo/dx4win > > _______________________________________________ Dx4win mailing list [email protected] http://mailman.qth.net/mailman/listinfo/dx4win
