On Sun, Aug 23, 2009 at 11:22 AM, Tibor M. Blum - IK2SAI
-<[email protected]> wrote:
> Tony,
>
> thank you for your email.
> I have downloaded the software and looks like just what I am looking for.
> Incidentally I do not have the K3 but the TS2000X and, for what I have seen
> there is no way to change the kind of rig.
>
> One missing point on my previous message is: with VSPE all runs ok if I
> connect only with dx4win.
> When HRD starts dx4win starts "to give numbers"...
> Any further ideas are welcome!
That's not surprising. DX4WIN assumes that it is the only software
talking to the rig. When you start up HRD and it starts sending
commands to the rig, DX4WIN will see responses it does not expect and
doesn't know how to handle them. If you can configure VSPE so that the
HRD virtual port is read-only (that is, it's not able to send commands
to the rig) then DX4WIN will probably work just fine. I don't know if
HRD will continue to work well enough for you in this configuration or
not.
73,
-Rick
--
Rick Murphy, CISSP-ISSAP, K1MU/4, Annandale VA USA
______________________________________________________________
Dx4win mailing list
Home: http://mailman.qth.net/mailman/listinfo/dx4win
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
