Good afternoon, Today I've run into something I haven't seen before with D4W: earlier in the day I noticed that the band and mode noted in the appropriate blocks on the QSO window did not reflect that information as shown on my radio -- no matter what I did, it came up as Mode=SSB and Band=6M. I turned everything (D4W Ver 7.07.02, microKeyer router program, and radio) off and did a hot reboot of the computer. No change.
I then turned everything off, including the computer, and let it sit for a couple of minutes, then fired the computer back up, started the router program for the microKeyer, turned on the radio, and then loaded D4W. It appeared that the problem had been solved. However, a couple of hours later I started to spot TI8II on 10 meter CW and found that the ALT-A shortcut to announce the spot came up with 20.35 as the frequency although the readout on the radio was 28.02035 AND the mode/band info in the QSO window was wrong again. I checked the router monitor screen (to see what info was going into the router from the radio) and found that the full, correct frequency was being sent by the radio and logged by the router monitor. It seems fairly clear that this problem must be in D4W but I've never run into this problem before beginning, I think, with Version 4.0 in 1999. Any info will be appreciated. The loss of the "announce spot" short-cut isn't really a big deal, but it appears that there is more going on (or perhaps failing to go on) than just that one feature. 73 and thanks in advance, Karl,K1KO Virginia Beach ______________________________________________________________ Dx4win mailing list Home: http://mailman.qth.net/mailman/listinfo/dx4win Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
