Hi Kostas, I just installed on my test setup a microHAM MKII + Stationmaster, It did setup quiet easy except for FSK with FT920, there seems to be a Problem in the rig. CW-PSK31-AFSK etc is working perfect. On my test pc the microham router is started minimized when booting up And I think this is the way it should be, not starting it up then can give You problems when you connect via USB another device that uses a comport It takes what is available, since your router isn´t running then it may conflict With your settings later on. Don´t compare the behavior of DX4WIN with WRITELOG because it is written in a different Code and acts different on comports being there or not. BTW the microham router doesn´t consume very much memory at all so it can be Started like you know when your computer starts.
Problem of USB comports not being there is a known problem but can´t be changed Guy ON4AOI > -----Oorspronkelijk bericht----- > Van: [email protected] [mailto:dx4win- > [email protected]] Namens Kostas Stamatis > Verzonden: maandag 16 november 2009 16:44 > Aan: REFLECTOR dx4win > Onderwerp: [Dx4win] dx4win crashes when microham router not run > > I use a microham mk2r+ for interface between dx4win and my rig. I have > assigned some com ports for rig control, ptt, fsk and one port for > winkey. > If i run dx4win without to load the microham router, dx4win gives me > some > messages that com ports are not there and finally opens. But when i try > to > save the log or to simply close the dx4win gives me a message like "an > exception occured! Thread Error: access not allowed (5)". I can not > close > dx4win except i terminate it via windows manager. This happens only if > i > have winkey selected and not if i have a (usb or normal) com port for > cw. I > had the same behaviour with k1el original keyer also and this happens > in > ver.7 also. > > How Writelog acts? Well when i start Writelog and i have not router > running, > it will open normally (without any message) and simply i have not rig > control, ptt, cw, etc. When i run the router all come back normally. > > I would like to know if this happens for you also ( i am not sure that > this > happens in all computers) and second if you prefer a similar to > writelog > behaviour. For example i would like dx4win says that com ports are > closed > but continues to work and when i start the router the com ports start > functioning (almost like writelog). > > Many times i want just to check the clusters spots and i want to run > dx4win > only for this. So i don't want to run the router every time i start > dx4win. > Sometimes also i forget to run the router before to run dx4win. It's > not a > big problem but an everyday problem for sure. I don't like to see > dx4win > crashes. By the way i know that i can have router start with Windows > but > because my computer is rather old and i use it for other work also, i > don't > like to load many things during startup. > > Kostas sv1dpi > > ______________________________________________________________ > Dx4win mailing list > Home: http://mailman.qth.net/mailman/listinfo/dx4win > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Dx4win mailing list Home: http://mailman.qth.net/mailman/listinfo/dx4win Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
