You have to install the LPT driver. It's a separate step in the installation process.
On 2011-02-16 20:26, Mike Bragassa wrote: > I cannot seem to get CW to key after the upgrade from ver.7.02 (and previous) > which have always upgraded w/ no problems. > Within Setup Parameters|CW I choose DX4win and LPT1 as I have always done. > I noticed that once I: > 1. Move up or down in the selections of Setup Parameters|CW and return to the > CW tab, the LPT1 selection is...gone. > 2. When I exit Setup Parameters, of course saving the changes and go to test > CW: No CW.. > > For some reason the LPT1 setting is not being saved. > > What is "1/2 Signal | None or Reverse" ? I had "1/2 signal" selected in my > previous version. Why? I don't recall. None of these seem to affect my > problem above. > > The upgrade has been registered. > > Any ideas before I go back to my previous version? > > 73 de Mike, K5UO > [email protected] > ______________________________________________________________ > Dx4win mailing list > Home: http://mailman.qth.net/mailman/listinfo/dx4win > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Dx4win mailing list Home: http://mailman.qth.net/mailman/listinfo/dx4win Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
