Yes to a specific comm Port....the one that matches the comm Port you are using to connect from your PC/ laptop to your radio. Yes to a specific data rate/ speed...the one you have set in the ftdx 5000 menu ( I use 38400, which is supported in my ftdx 3000 menu and I'm sure is also on your 5000.... under the heading of cat rate). You also have to match either DTR or CTS....I think it's DTR bit I'll have to check. Probably should be set to high most likely.
Tim Moore/K4TK On Wed, Dec 19, 2018, 3:14 PM Steve Hart <[email protected] wrote: > Using Win 10 current version, Yaesu FTdx5000, and cannot get them to talk > to each other. Using the serial port on the 5000, an RT Systems USB-63 > cable w/the FD-11 chipset, and a USB connector on the other end. I’m > assuming I have a comport assignment problem. Is there a specific comport > number, speed,etc that I should be using for each? Tnx/73 Steve > [email protected] > ______________________________________________________________ > DX4WIN mailing list > Home: http://mailman.qth.net/mailman/listinfo/dx4win > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > Message delivered to [email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ DX4WIN mailing list Home: http://mailman.qth.net/mailman/listinfo/dx4win Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] Message delivered to [email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
