I got a new MKIIG also and had not tried it but after seeing your message I went and tried. I notice that the MKIIG was not listed so I tried the 706MK2 in the radio settings, this would not work, then I thought about all the different Icom radios having different HEX addresses. I then went to my DXBase folder and opened the "Radios.ini" file in Notepad, do a Find for 706MK2 then scroll down a little and find the line with "Address = 0x4e"(I think the 4e is correct. Change this lint to read "Address = 0x58" Save the newly edited Radios.ini and now it will work using the 706MK2 radio setting. I user the fastest speed that the radio supports 19200 and 8,N,1 Hope this helps
73 de Tony, KD4K My Weather Page http://home.adelphia.net/~tonycash/ My Ham Radio Page http://home.adelphia.net/~tonycash/kd4k/radio.html Sawnee Mountain (WB4GQX 147.15 +.600) Repeater Page http://home.adelphia.net/~tonycash/sawnee/index.html ----- Original Message ----- From: "Jack" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]>; <[email protected]> Sent: Saturday, November 16, 2002 6:07 PM Subject: Re: [DXBase] controlling Icom 706MKIIG > Most early ICOMs used 1200, 8, N, 1 but since some of these settings can be > modified within the radio, you will probably need to confirm what your > particular radio is set for. Also, some of these radios have autobaud > detect option. Don't use this, but instead, set a specific baud rate and > then set DXbase to agree with what you have set in the radio. > > Regards, > Courtney > > ----- Original Message ----- > From: <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Saturday, November 16, 2002 1:33 PM > Subject: [DXBase] controlling Icom 706MKIIG > > > > Has anyone had any success controlling an Icom 706MKIIG from DXBase. If so > can > > you please tell me what settings you used (baud rate, parity, bit, and > stop > > bit)? > > > > Thanks > > _______________________________________________ > > DXBase Reflector - Please visit us on the web at www.dxbase.com > > - - - - - - - - - - - - - - - - - - - - - - - > > To UNSUBSCRIBE please visit: > > http://mailman.qth.net/mailman/listinfo/dxbase > > > > > _______________________________________________ > DXBase Reflector - Please visit us on the web at www.dxbase.com > - - - - - - - - - - - - - - - - - - - - - - - > To UNSUBSCRIBE please visit: > http://mailman.qth.net/mailman/listinfo/dxbase >
