I am using the 756ProII with DXB2004 just fine. Here is my set up: CT-17 controller On set up page I have selected the ICOM 756Pro rather than the ProII for reasons I explain below. Remaining set up: Connect HF Radio 1 DTR High COM4 19200/None/8/1 Address 5c
I have my ProII set up with an address of 5c, which is the address used for the Pro. I do this because I also use WriteLog and it has no set up for the ProII, only for the Pro. Check your 756ProII manual for information on how to set up its address. There is no reason you cannot select ProII in DXB2004 and use the default address for the ProII in the radio. The key point is that the address used must correspond to the radio selected in DXB2004. Ron, N5IN ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[email protected]> Sent: Sunday, June 01, 2003 8:24 PM Subject: [DXBase] ICOM 756-PROII Rig Control > I am unable to get DXB 2004 to read the frequency when logging QSOs. This > was also a problem in DXB 2003 and someone on the reflector sent me a file that > worked great to control the rig and talked me through installation. If anyone > else has had the same problem and found a remedy, I would appreciate some > assistance. Thank you. > > Tom Neill, K4XG > Windy Hills Farm > 6500 Covington-Eudailey Road > College Grove, TN 37046 > > > --- StripMime Report -- processed MIME parts --- > multipart/alternative > text/plain (text body -- kept) > text/html > The reason this message is shown is because the post was in HTML > or had an attachment. Attachments are not allowed. To learn how > to post in Plain-Text go to: http://www.expita.com/nomime.html --- > _______________________________________________ > DXBase Reflector - Please visit us on the web at www.dxbase.com > - - - - - - - - - - - - - - - - - - - - - - - > To UNSUBSCRIBE please visit: > http://mailman.qth.net/mailman/listinfo/dxbase >
