Downloaded the ProIII pdf....unfortunately they have not corrected the problem which is the lack of any ability to sense the current state of the radios split and dualwatch status.
I have contacted several management people at ICOM, by e-mail and in person for the last 3 years explaining that they are the only one of the major radio manufactuers that does not allow the status of dual watch and split to be sensed via the serial port. Without this capability it's impossible for a logging program to do a complete job of putting the correct frequencies in the log and to generate dx spots. Kenwood and Yaesu both have this essential capability. I have just about lost all hope for ICOM! I would have bought the Pro III, but now I have given up on them and will look elsewhere! Ron, N5IN Per Molund wrote: > > The user manual can be downloaded from icom at > > http://www.icom.co.jp/manual/external/transceivers/IC-756PROIII.pdf > > however there are no schematics if You are in need of them. > > regards, > > ---per > LA9XKA > > At 17:20 24.11.2004, you wrote: > > >> So the first step will be to get a copy of the interface spec's. >> >> Ron, N5IN >> ______________________________________________________________ > > From [EMAIL PROTECTED] Fri Nov 26 08:22:36 2004 From: [EMAIL PROTECTED] (Jim McDonald) Date: Fri Nov 26 08:29:32 2004 Subject: [Dxbase] K1EL's WinKey Message-ID: <[EMAIL PROTECTED]> I can't get the speed pot of my new K1EL WinKey to work with DXbase. I have it connected with three wires and have the POTRANGE set to 255. I can vary the speed from DXbase but not using the pot. I have tried setting the speed in the DXbase CW parameter screen to 0, thinking that might enable the pot but no luck. I'll check my wiring. I'm using it with a PROII. Any other parameter tips will be appreciated. Jim N7US
