The K1EL speed pot now works. I had forgotten to install a shorting wire (a 0 ohm resistor). Setting the speed to 0, I can get the pot to work, and the minimum speed setting works OK (as long as I turn off Farnsworth), but the upper speed isn't working. The actual limit is greater than the speed I specify. Anyone else have that working OK?
Jim N7US -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Jim McDonald Sent: Friday, November 26, 2004 6:23 AM To: Dxbase Reflector Subject: [Dxbase] K1EL's WinKey I can't get the speed pot of my new K1EL WinKey to work with DXbase. I have it connected with three wires and have the POTRANGE set to 255. I can vary the speed from DXbase but not using the pot. I have tried setting the speed in the DXbase CW parameter screen to 0, thinking that might enable the pot but no luck. I'll check my wiring. I'm using it with a PROII. Any other parameter tips will be appreciated. Jim N7US
