Oooops I meant with Ham V you get DCU-1 ... SRI
At 01:26 PM 4/14/2005, Al Bailey wrote: >Ham IV and Ham V are exact same rotor BUT with Ham IV you get the DCU-1 >controller... > > > > > >At 01:20 PM 4/14/2005, Jack wrote: >>I am unfamiliar with there being a Hygain HAM V. I know that there was a >>Ham IV and also a Tx2. In any case, the answer of whether a rotor would >>work with software control from DXbase would depend upon the rotor >>control box's ability to support RS232 interface, and whether the >>commands required could be set up in DXbase user options. Or possibly >>the rotor emulates the commands of some other existing rotor and could >>therefore use that. >> >>Regards, >>Jack >> >>----- Original Message ----- From: "JNMazzoni" <[EMAIL PROTECTED]> >>To: <[email protected]> >>Sent: Thursday, April 14, 2005 11:28 AM >>Subject: [Dxbase] Rotor Interface >> >> >>Is dxbase 2005 compatable with hy-gain's HAM-V rotator? >>______________________________________________________________ >>Dxbase mailing list >>Home: http://mailman.qth.net/mailman/listinfo/dxbase >>Help: http://mailman.qth.net/mmfaq.htm >>Post: mailto:[email protected] >> >>______________________________________________________________ >>Dxbase mailing list >>Home: http://mailman.qth.net/mailman/listinfo/dxbase >>Help: http://mailman.qth.net/mmfaq.htm >>Post: mailto:[email protected] > > > >______________________________________________________________ >Dxbase mailing list >Home: http://mailman.qth.net/mailman/listinfo/dxbase >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected]
