Is the internal PSK31 mode supported in 2005? Help says use 2002. This doesn't sound right. I tried to install PSK31 from the programs menu and got an unsupported error. Using XPpro and checked XP in the drivers window. JV From [EMAIL PROTECTED] Sun Mar 13 12:41:13 2005 From: [EMAIL PROTECTED] (Jim) Date: Sun Mar 13 12:44:11 2005 Subject: [Dxbase] Band change In-Reply-To: <[EMAIL PROTECTED]> Message-ID: <[EMAIL PROTECTED]>
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Kamar Sent: Thursday, December 23, 2004 2:05 PM To: [EMAIL PROTECTED]; 'DXbase Mailing List' Subject: RE: [Dxbase] DXBase 2005 - Orion issue Bill, You can change Dxbase 2005 CW default mode to LCW for the Orion by doing the following: You are going to modify Dxbase's 'radios.ini' file located in YourDrive:/Scientific Solutions/Dxbase folder. FIRST!!!!!!!!!! SAVE A COPY OF THE RADIOS.INI FILE TO A SAFE PLACE. Using NotePad or any TXT Editor open the file 'radios.ini'. Scroll down to the radio script labeled [TENTEC_ORION565] Change The equal values in the following lines: P_CW=2 to 3 P_CWR=3 to 2 CW=2 to 3 CWR=3 to 2 DefaultCW=2 to 3 DefaultCWR=3 to 2 Also, note that Dxbase 2005 does allow you to switch the CW modes (CW (default) or CWR) using 'Set HF Frequency' located under Tools. However, this tool uses the dafault CW and CWR settings in the radios.ini file. It does not 'switch' from one CW mode to the other on a permanent basis. To switch the CW mode for a particular station Click the Set HF Frequency Retrieve button and select CWR (or CW) under mode, and then click the QSY button. I briefly tested the above settings and seem to work OK here. Let me know if you have any problems REMEMBER, SAVE the RADIOS.INI FILE BEFORE MODIFYING IT !!!!!!!!!!!!!! Ron ... NU1U I have been using DXbase for several years and must have changed a setting and have been unable to figure out what I changed. Using either Commander, N4PY or Ham Radio deluxe I am able to band switch my Icom Rig along with my SteppIr Beam. In other words all track together, when the rig changes bands and so does the Steppir. Now, DXBase 2005 would do the same but I have noticed recently the rig will band switch but not the Steppir. Somewhere I must have changed a needed setting in the DXBase program. I am open for suggestions. Jim
