Bob, When you want to use that particular qsl card file, you MUST tell the program (for the QSOs per Label) 20 !!! That card file is made for a MAXIMUM of 20 QSO's per card .. therefore, no matter how many qsos you actually have to be printed on the card, you MUST still tell the program 20 in the QSOs per Label window.. Then that error will never be seen.
73 Joe wa6axe Bob McAuley wrote: > When I try to open the contestqsl20qsbackedge.crd file to modify it I > get the following error: > > Expression Error > Text (1.291in, 1.622in,1.411in, 2.522in) > Expression Mode 4 > Error > Syntax Error: cannot interprete term "mode 4". > > Once I hit "Okay to all". It opens the file in the editor. However, it > is annoying. Any one know why this is happening? > > Bob > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > From [EMAIL PROTECTED] Wed May 25 09:16:13 2005 From: [EMAIL PROTECTED] (FireBrick) Date: Wed May 25 09:26:52 2005 Subject: [Dxbase] Error Message References: <[EMAIL PROTECTED]> <[EMAIL PROTECTED]> Message-ID: <[EMAIL PROTECTED]> Wow Joe, I got your reply BEFORE I got Bob's question. LOL You must be psychic. That shows how good DXB support is. They put out the answers to help requests before they are asked. ----- Original Message ----- From: "Joseph Glockner" <[EMAIL PROTECTED]> To: "Bob McAuley" <[EMAIL PROTECTED]> Cc: <[email protected]> Sent: Wednesday, May 25, 2005 8:11 AM Subject: Re: [Dxbase] Error Message > Bob, > > When you want to use that particular qsl card file, > you MUST tell the program (for the QSOs per Label) > 20 !!! That card file is made for a MAXIMUM of > 20 QSO's per card .. therefore, no matter how many > qsos you actually have to be printed on the card, > you MUST still tell the program 20 in the QSOs > per Label window.. Then that error will never be > seen. > > 73 Joe wa6axe > > Bob McAuley wrote: >> When I try to open the contestqsl20qsbackedge.crd file to modify it I get >> the following >> error: >> >> Expression Error >> Text (1.291in, 1.622in,1.411in, 2.522in) >> Expression Mode 4 >> Error >> Syntax Error: cannot interprete term "mode 4". >> >> Once I hit "Okay to all". It opens the file in the editor. However, it is >> annoying. Any >> one know why this is happening? >> >> Bob >> ______________________________________________________________ >> Dxbase mailing list >> Home: http://mailman.qth.net/mailman/listinfo/dxbase >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] >
