I am using the Pegasus Radio interface with DXBase 2005 and the N4PY software. I am using this configuration to allow the N4PY software to poll my Ten-Tec Orion radio for its frequency so that the SteppIR antenna will tune to the correct frequency when the transceiver frequency is changed.
The "Reset HF Frequency" command does not work with the Pegasus Interface. Can that be fixed? Thanks, Merle - W0EWM From [EMAIL PROTECTED] Thu Sep 22 16:30:46 2005 From: [EMAIL PROTECTED] (Joseph Pontek Sr) Date: Thu Sep 22 16:39:18 2005 Subject: [Dxbase] WinKey and the com port Message-ID: <[EMAIL PROTECTED]> After some detective work, I, finally, got my WinKey to work, in WKXP, N1MM and DXBase2006. I am currently handicapped until my new comport card comes in to give me more than one comport. What I have run into are a couple of issues. 1) Even though I did not have the "connect radio to com port" box checked, I could not run WinKey until I actually said "None" for radio. I could have probably changed the port number to a another port even though I do not have it now. 2) The real concern is, after I shut down DXBase2006, I went to WKXP and could not open WinKey again. Not until I opened DXBase, unselected WinKey, then shut DXBase back down, could I open WKXP. DXBase, apparently, tied up com 1, even though it was shut down. Once I get the other com ports installed, issue one will not be a problem, but 2) will be a real hassle if I have to go through that every time I switch programs. Is this normal or am I doing something wrong? I am new to DXBase Windows and Windows XP OS. -- Best regards de V31Joe"Palooka" Joe & Bev Pontek, Sr. 26441 Devaney Road Arcadia, IN 46030-9532 USA 317-984-7388 or P.O. Box 280 Dangriga Stann Creek District Belize 501-520-7072 V31JP K8JP VP5/K8JP VP5JP K8JP/VA2 [EMAIL PROTECTED] http://mywebpage.netscape.com/v31jp/homepage.html
