Thanks for all the replies about my poor missing toolbar. After trying to make Joe loose his mind we were able to get the simple answer from Jack. It seems the answer is right in the help files. I did search after search looking for the "Previous QSO Window or Toolbar" when the answer was to look for toolbars in general. Apparently there is an anomaly that occasionally lets toolbars disappear even when they are checked to be viewed. I ran through the steps in the help file and all is well with the toolbars again.
Thanks again to all and especially Joe who has always been a big help. And Jack for the final answer. Phil N9LAH From [EMAIL PROTECTED] Fri Jun 22 08:17:18 2007 From: [EMAIL PROTECTED] (Bill Parry) Date: Fri Jun 22 08:22:30 2007 Subject: [Dxbase] DXB 2005/2007 Message-ID: <[EMAIL PROTECTED]> I just discovered I had done something stupid this morning. About a month ago I installed DXB2007 on my computer. The install worked very nicely and I imported my appx 50K QSOs. I did not uninstall my old DXB2005. I just noticed this morning that I had reopened the DXB2005 and had been using it since that time to log all the QSOs this month - probably about 100. I leave my DXB running all the time because my computer is slow and takes for every to boot up. So. What is the most convenient way to get those 100 QSOs over onto DXB2007. Should I use the selection wizard and select those QSOs and make an adi file, then import those QSOs into DXB2007? Shall I just re-import the whole log? (Would that create double entries for all those QSLs?) One thing I will be sure to do is remove the DXB2005 Icon off my desktop!! :-) Bill, W5VX
