running dxbase 2007 and windows vista have noticed new and minor problem, when i am imputing new entries i cannot get dxbase to populate name, state etc from hamcall which i have on my c drive, any solutions to this. thanks joe kl7lf From [EMAIL PROTECTED] Sat Mar 8 20:57:36 2008 From: [EMAIL PROTECTED] (joe voelkelt) Date: Sat Mar 8 21:02:36 2008 Subject: [Dxbase] dx base and windows vista Message-ID: <[EMAIL PROTECTED]>
running dxbase 2007 and windows vista have noticed new and minor problem, when i am imputing new entries i cannot get dxbase to populate name, state etc from hamcall which i have on my c drive, any solutions to this. thanks joe kl7lf From [EMAIL PROTECTED] Sun Mar 9 09:28:24 2008 From: [EMAIL PROTECTED] (Jack) Date: Sun Mar 9 08:33:21 2008 Subject: [Dxbase] dx base and windows vista References: <[EMAIL PROTECTED]> Message-ID: <[EMAIL PROTECTED]> Joe, To the best of my knowledge, there are no issues with this interface and Vista. I suspect you have not followed the instructions in the help file to set this interface up. You must copy the CD data files as listed below. After doing that, you need to set the DXbase options in the directory tab and the log tab. HamCall, or sometimes referred to as BuckMaster, contains a folder on the CD called ham0. This is the folder that contains all of the address related files. 1. Using Windows Explorer, create a new folder on your hard drive under the root folder called ham0. Note that this uses a numeric zero and not an alpha O. Do NOT place this new folder under other subfolders. It must be located directly under your root folder. 2. Using Windows Explorer, click on the left side on the ham0 folder of the CD. 3. You should see the address related files on the right. Using the main menu, click Edit/Select All. 4. On the main menu of Windows Explorer, click Edit/Copy 5. Click on the ham0 folder that you created in step one above. 6. On the main menu of Windows Explorer, click Edit/Paste If the above was done correctly, you will have a folder on your hard drive with a full path of C:\ham0 where C is the designation for your hard drive And, you will have the address related files listed on the right side of Windows Explorer Copyright ?1999 - 2006 Scientific Solutions, Inc. ----- Original Message ----- From: "joe voelkelt" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Saturday, March 08, 2008 8:57 PM Subject: [Dxbase] dx base and windows vista running dxbase 2007 and windows vista have noticed new and minor problem, when i am imputing new entries i cannot get dxbase to populate name, state etc from hamcall which i have on my c drive, any solutions to this. thanks joe kl7lf ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
