Frank, we need a little more information on your problems. The most important thing is that your radio address and baud rate match up with the virtual port that you created using the microHam interface. Please tell us what you have done. The proper steps are:
1. Using the set up menu under others set your radio address (probably 6Ah) and the CI-V Baud Rate. I use 19200 but anything down to 9600 should work. The important thing is you know what it is. 2. Using the microHam interface router software under the Ports tab, assign an unused port number ie: COM5 to the Radio then click on the "Set" button on the right this should open another sub window where you can select the Icom 7800, address and baud rate. Frank check all of these things and make sure your cable that you purchased from MicroHam is properly plugged into the radio and usb interface. 73's es good luck Joe Frank, IZ7AUH wrote: > Hi Guys, > I have some problem to manage by microHAM USB Interface II and DXbase my > IC-7800 > There are some incompatibility with it? > Please help me. > > 73 de IZ7AUH > > > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > > From [EMAIL PROTECTED] Fri Mar 21 17:59:20 2008 From: [EMAIL PROTECTED] (Joseph Glockner) Date: Fri Mar 21 18:05:28 2008 Subject: [Dxbase] E7 Bosnia and Herzegovina -- FYI - using NEW E7 calls Message-ID: <[EMAIL PROTECTED]> To all: I have seen in the DX newsletters that "E7 Bosnia and Herzegovina" will START using their E7 callsigns at March 21, 2008 2300Z ( in a few minutes ) .. For those who have not updated their Refdata.mdb file to show the Primary Prefix for Bosnia and Herzegovina as being E7 -- you might want to do so. For those who want to use my autoupdate exe file(s) you can visit: http://www.navycthistory.com/wa6axe/selection.html and click-on the LINK for DXbase 2006 or 2007 autoupdate exe files (ZIP file) .. 73 Joe wa6axe From [EMAIL PROTECTED] Sat Mar 22 08:45:04 2008 From: [EMAIL PROTECTED] (W6IZT) Date: Sat Mar 22 08:51:20 2008 Subject: [Dxbase] DXB2007 QSL question In-Reply-To: <[EMAIL PROTECTED]> Message-ID: <[EMAIL PROTECTED]> This may be an obvious question, but I am stumped. How do I configure DXB2007 to print QSL and Manager labels for all unconfirmed DXCC entities for all bands SSB + CW. Thanks in advance for your help Gregg W6IZT
