The solution to this problem (not serious enough to be an "issue" :-) ) is: Tools, Options, User Options, Rotor-1, check "Use leading zeros in degrees" box. Works fine now.
--- On Fri, 7/25/08, Joe Young <[EMAIL PROTECTED]> wrote: From: Joe Young <[EMAIL PROTECTED]> Subject: [Dxbase] Fw: Green Heron Engineering Rotor Control and DXbase2007 To: [email protected] Date: Friday, July 25, 2008, 3:30 PM --- On Fri, 7/25/08, Joe Young <[EMAIL PROTECTED]> wrote: From: Joe Young <[EMAIL PROTECTED]> Subject: Green Heron Engineering Rotor Control and DXbase2007 To: [email protected] Date: Friday, July 25, 2008, 3:20 PM I have an RT-21 controller here that functions as it should on another logger. When using this unit with DXbase 2007 all seems to function OK on Long Path move requests but on Short Path move requests there is either no movement or there is a movement but to an incorrect azimuth. I have set the default settings (DCU-1) in the rotor control (number 1) window and activated the rotor control in the rotor options window. Using another logger that provides a rotor control debug window I see: Example: Heading SP of 60 degrees. 'AP1060;<cr>AM1;<cr>' LP request for same target. 'AP1240;<cr>AM1;<cr>' Both of the above cause the correct movement. I cannot see what the DXbase commands are. Maybe I am missing another setting within DXbase? Thanks for reading de Joe/W6RLL ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
