If you use "CW Line Out" it will show the characters until you hit enter at the end of a line. At least this way you see what you have typed for a little while. 73 de Tony, KD4K
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Eric - VE3GSI Sent: Tuesday, March 10, 2009 10:20 AM To: [email protected]; [email protected] Subject: Re: [Dxbase] Dxbase / Winkeyer Question Hi Paul, Your Winkey interface is not broken, the CW terminal program in DXBase does not echo or display keystrokes. Perhaps Jack will looked-see what the problem is in a future upgrade to DXbase. Eric - VE3GSI > -----Original Message----- > From: Paul > Sent: March-10-09 9:23 AM > Subject: [Dxbase] Dxbase / Winkeyer Question > > Hello Group, > I am new to the group. I have been using DXbase for a couple of years. > I > purchased a Winkeyer USB to to interface with it. Seems to work fine > with > one problem. DXbase does not echo the keystrokes back to the screen so > I > cannot see what I have typed. Does anyone have any suggestions to fix > this > or has anyone else run into this?? I do have the serial echo block > checked. > Thanks. > Paul - N1PD > ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
