Does anyone have any advice for Paul? I am not so sure what the problem is so am asking for your help!
73 Neal Campbell Abroham Neal Software www.abrohamnealsoftware.com (540) 242 0911 Amateur Radio: K3NC Blog: http://www.abrohamnealsoftware.com/blog/ DXBase bug reports: email to [email protected] Abroham Neal forums: http:/www.abrohamnealsoftware.com/community/ ---------- Forwarded message ---------- From: <[email protected]> Date: Tue, Dec 1, 2009 at 5:23 PM Subject: cw regedit code dxbase7 registred To: [email protected] hi dear Sir, quick V 1.04.. cw trouble after a fews days because windowsxp, dxbase corrrupt by a loading program ??? I dont know ?? I use com1 original com from mother board..3f8 cw keyer... internal dxbase ........... all ok with others sw mixwin etc etc.. I think the port com is dont'open by the dxbase... If open it by a other sw on the com1...........the cw out is good!! on the regedit............all code is the same of your specs... ONLY Ignore conflits are 0x00000000 not 00000001 port base is good 3f8 portcount is good 7 please where is the trouble ??? of course I modified 0 to 1 but the trouble are alsway here ... no cw output NB CAT RUN COM 2 but the CAT lcd front panel of my 1000mp is only active with a dx click after... no flash. for me is right ?? your opinion please MERCI 73 PAUL F5QE ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
