I have always just entered the call again (correctly) then delete the line that is incorrect after.....
Dave Garber VE3WEJ ----- Original Message ----- From: "Bill Parry" <[email protected]> To: <[email protected]> Sent: Saturday, December 26, 2009 9:48 AM Subject: [Dxbase] checkwpx report >I was fooling around this morning looking at some of the reports that are > available and I found something that probably needs to be looked at during > the next upgrade of DXBase...(unless I don't know what I am doing!) > > When I enter a call sign when I am going to work someone, sometimes I > enter > the call wrong! Let's say I enter W4LPL instead of W3LPL. When I hit the > tab key all of the info is filled in boxes like it should be. It will > enter > W4 as the prefix. If then I figure out my error and correct the call, the > prefix STAYS INCORRECLY ENTERED. Not to mention some of the other data. > > It would be nice if, when you correct the call, the rest of the data is > updated ...like the CQ Zone, ITU Zone, prefix etc. > > Is it possible to fix this? > > Bill W5VX > > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
