Yes. Go to the Selection Wizard and click on the QSO Filters button. Make sure all boxes on the filter screen are unchecked. Then check Band=30 and Confirm=None. Click on OK to return to the first screen. Set the Output Type box to Labels and check the "Test only" box. Click on Start and watch how many QSO Labels DXB would print with this set of filters. If the result seems logical uncheck the "Test only" box and click the Start button again. This time DXB will put all the QSO labels matching the filter limits in the Pending QSO's file for you to print the labels.
73, Gary AL9A ----- Original Message ----- From: "Steve Rutledge" <[email protected]> To: "DXBase Reflector" <[email protected]> Sent: January 03, 2010 4:40 PM Subject: [Dxbase] Selective QSL Printing????? > Is there a way to select all unconfirmed 30 meter cards and print labels > for those QSOs?????? > > I know I could search my entire log and mark them but I'm looking for > the easy way out. > > Regards, > > Steve, N4JQQ > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
