Gary, Thank you for the help. I had done almost all of the steps you described below. In the logging program connection, I had not enabled Telenet. I could not connect to 127.0.0.1:7300, so connected to VE7CC-1 node, I think. Bad thing to do when AR User is already connected to that node. Anyhow, now its working the way it is supposed to work. Thanks again!! 73, Bob K6ASK
________________________________ From: Gary AL9A <a...@mtaonline.net> To: BOB MUELLER <k6...@yahoo.com>; DXBase <dxbase@mailman.qth.net> Sent: Wednesday, August 29, 2012 3:57 PM Subject: Re: [Dxbase] Using CC User with DXbase 2007 Bob, I'm assuming you are using Telnet rather than TNC. In AR User click on Configuration/Ports/Logging Program. In the Node Connection click on Telnet and set Data bits: 8, Parity: N, Stop bits: 1, Flow Control: Hardware. In the Logging Program Connection area click on Enable Telnet and Use Port 7300. In the Data Sent to Logging Program area select the items you want sent to DXB. In DXBase 2007 go to Tools/Options/User Options and click on the Internet tab. Lots of options here so select the ones you enabled. At the bottom left of the window is an area called IP Host. Look for a line in your Hosts file that says 127.0.0.1:7300 #AR USER. If it's not there you can edit the Hosts file to add the line by going to File/Modify Hosts File... When you get to the Edit Host File window hit F1 to bring up the Help file section relating to this window and review the instructions on how to add a new line of info to the Hosts file. Once you have the correct line selected in the Hosts file, click on Window/New Internet Cluster. A Internet Cluster window will open (sometimes it is minimized and you have to look for it behind other windows on the desktop) and spots should start showing up in the DX Info window. 73, Gary AL9A ----- Original Message ----- From: "BOB MUELLER" <k6...@yahoo.com> To: "Neal Campbell" <abrohamn...@gmail.com>; "Terry" <te...@k8smc.net>; "DXBase" <dxbase@mailman.qth.net> Sent: August 29, 2012 1:07 PM Subject: [Dxbase] Using CC User with DXbase 2007 All, Not doing something correctly! Need some help. Bet it's simple, but my inexperience with this sort of thing is showing. When trying to utilize the capabilities of AR User to filter spots coming from VE7CC-1, I seem to be connecting incorrectly, which results in connecting to AD User via two ssids. I can connect to VE7CC-1 node with AR user. No problem there, I think! How do I direct the filtered output from AR User to be displayed in DXbase 2007? 73, Bob K6ASK ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Dxbase@mailman.qth.net This list hosted by: http://www.qsl.net/ Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Dxbase@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
