Of course, that would make understanding why it was modified a bit harder.
But in my opinion, changing it back to 0 shouldn't break the code. I can't
see anything else being influenced by Z indexes.
----- Original Message -----
From: "Michael Pemberton" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Tuesday, May 29, 2001 4:59 PM
Subject: Re: [Dynapi-Dev] ZIndex problems
> i am not sure as to the reason, but I found that the change from 0 -> null
> happened back in late february (revision 1.32).
>
> it just so happens that pascal was the person that submitted the update
: )
>
> Daniel Holmen wrote:
>
> > Then I think index 0 should be used in the new version aswell (unless
this
> > was removed due to some horrible bug).
> >
> > ----- Original Message -----
> > From: "Michael Pemberton" <[EMAIL PROTECTED]>
> > To: <[EMAIL PROTECTED]>
> > Sent: Tuesday, May 29, 2001 2:33 PM
> > Subject: Re: [Dynapi-Dev] ZIndex problems
> >
> > > this is because the old version (I just checked the code from the
> > 2001.01.25
> > > release) had 0 as the default index value. This is why it didn't have
the
> > > problem.
> > >
> > > Daniel Holmen wrote:
> > >
> > > > In NS4 you can set the Z Index AFTER the layer is created. But if
you
> > > > specify a Z Index before it is created, NS ignores it totally.
> > > >
> > > > I never had any of these problems with the old (non DynAPIX) DynAPI
> > though.
---snipped
_______________________________________________
Dynapi-Dev mailing list
[EMAIL PROTECTED]
http://lists.sourceforge.net/lists/listinfo/dynapi-dev
