I am using frames and I have gone over most messages concerning DynDocuments
but I have found nothing to state HOW to check for the load state? Does the
DynDocument throw an "onload" event that I have not been about to find?
M.
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Cameron Hart
Sent: Friday, December 15, 2000 1:59 AM
To: [EMAIL PROTECTED]
Subject: RE: [Dynapi-Help] DynDocument
Perhaps. Are you using framesets? I haven't tried this myself, but if you
have the DynAPI in one frame, you could perhaps set the other frame to be a
DynDocument and listen for Load events.
There's been a bit of discussion on the list about using frames, it might be
worth going over some of those posts.
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Matthew
> Shirey
> Sent: 14 December 2000 20:41
> To: Dynapi-Help
> Subject: [Dynapi-Help] DynDocument
>
>
> This is my second post on this subject. I didn't get any response to the
> first... =(
>
> When you use the load() method of the DynDocument object, is there any way
> to tell when the load completes?
>
>
> M.
>
> _______________________________________________
> Dynapi-Help mailing list
> [EMAIL PROTECTED]
> http://lists.sourceforge.net/mailman/listinfo/dynapi-help
_______________________________________________
Dynapi-Help mailing list
[EMAIL PROTECTED]
http://lists.sourceforge.net/mailman/listinfo/dynapi-help
_______________________________________________
Dynapi-Help mailing list
[EMAIL PROTECTED]
http://lists.sourceforge.net/mailman/listinfo/dynapi-help
