Hi On Mon, 3 Aug 2009 03:32:04 +0200 Janusz Krzysztofik <[email protected]> wrote:
> This patch tries to correct the problem of full duplex mode not working > over a single McBSP based CPU DAI. > > Created against linux-2.6.31-rc5. > Tested on Amstrad Delta. > Do you have some specific test case how to trigger this? I haven't seen this on 2420 or 34xx (e.g. with 'arecord -d 1 -f dat |aplay') but I have no doubt that this can happen on 1510. At least this doesn't cause any harm on Beagle so I'm fine with the fix. > @@ -191,6 +192,14 @@ static int omap_mcbsp_dai_trigger(struct > case SNDRV_PCM_TRIGGER_PAUSE_RELEASE: > if (!mcbsp_data->active++) > omap_mcbsp_start(mcbsp_data->bus_id); > + else if (substream->stream == SNDRV_PCM_STREAM_PLAYBACK) > + /* looks like capture already in progress, > + * start playback by taking it out of error condition */ > + omap_mcbsp_pollwrite(mcbsp_data->bus_id, 0x0); > + else > + /* looks like playback already in progress, > + * start capture by taking it out of error condition */ > + omap_mcbsp_pollread(mcbsp_data->bus_id, &buf); > break; Minor note: See preferred style for multi-line comments in Documentation/CodingStyle. I'm not 100 % sure about the braces but I think they are also preferred if there are indented comment lines with the single code line. -- Jarkko _______________________________________________ e3-hacking mailing list [email protected] http://www.earth.li/cgi-bin/mailman/listinfo/e3-hacking
