Hi Jianliang, As Gilles mentioned you can read/write CMVs to check/setup ADSL standards, specifically: For setup:
OPTN 4, bits 1:0 00 = Multimode (G.dmt and T1.413) 01 = G.dmt only 10 = T1.413 only To check how the link came up: STAT 0, bit 4 1 = G.dmt mode 0 = T1.413 mode Rouzbeh ________________________________ From: [EMAIL PROTECTED] on behalf of Gilles Espinasse Sent: Fri 8/26/2005 4:06 PM To: [EMAIL PROTECTED]; eagle-usb driver developments Subject: Re: [Eagleusb-dev] How to configure ADSL_STANDARD on eagle modem ----- Original Message ----- From: "Jianliang Lu" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Friday, August 26, 2005 7:10 PM Subject: [Eagleusb-dev] How to configure ADSL_STANDARD on eagle modem > Hi all, > during our test for eagle-II modem we have had the problem to sync > with Siemens chipset infineon. We think that may be a adsl > operation mode setting problem. We'd like to know how to set the > adsl operation mode (standard, like G.992.x, T1.413 etc.), and how > can we get the information about the setting on modem. This > information was showed in Cxacru driver for Conexant Access Runner > chipset, but I don't know if we can get it also on eagle-usb > driver. > > Regards, > > Jianliang Lu > information is in CMV Manual 1-22-2002.pdf send to the list by ADI at page 129 for ATU-C (dslam side) at page 131 for ATU-R so the one for our side To my understanding, OPTN.adsl_standard is optn4 according to page 16 It only remain now to use the various bits and calculate desirated optn4 value. Gilles _______________________________________________ Eagleusb-dev mailing list [email protected] https://mail.gna.org/listinfo/eagleusb-dev
