Hi Peleg, If you have set the environment variable $EASYBUILD_PREFIX then it should be as simple as: rm -r $EASYBUILD_PREFIX Just be careful to check EASYBUILD_PREFIX first, if it is not set set the default is '$HOME/.local/easybuild' (I think) so just remove that instead. (Note: If you have a non-standard setup this may not remove everything)
Alan On 12 October 2017 at 16:13, Peleg Bar-Sapir <[email protected]<mailto:[email protected]>> wrote: Hello, as part of performing some tests, I would like to completely remove easybuild from my machine (including the python modules). Is there a general way to do so? I couldn't find any relevant info online. Best, Peleg -- Dr. Alan O'Cais E-CAM Software Manager Juelich Supercomputing Centre Forschungszentrum Juelich GmbH 52425 Juelich, Germany Phone: +49 2461 61 5213 Fax: +49 2461 61 6656 E-mail: [email protected]<mailto:[email protected]> WWW: http://www.fz-juelich.de/ias/jsc/EN ------------------------------------------------------------------------------------------------ ------------------------------------------------------------------------------------------------ Forschungszentrum Juelich GmbH 52425 Juelich Sitz der Gesellschaft: Juelich Eingetragen im Handelsregister des Amtsgerichts Dueren Nr. HR B 3498 Vorsitzender des Aufsichtsrats: MinDir Dr. Karl Eugen Huthmacher Geschaeftsfuehrung: Prof. Dr.-Ing. Wolfgang Marquardt (Vorsitzender), Karsten Beneke (stellv. Vorsitzender), Prof. Dr.-Ing. Harald Bolt, Prof. Dr. Sebastian M. Schmidt ------------------------------------------------------------------------------------------------ ------------------------------------------------------------------------------------------------
