Hi Andrew, I agree that I have something not set up correctly.
Its not the correct flash for the IXDPG425, however the changes that were recommended for the switch to the P30 do not work as hoped. I was actually hoping that someone had already gone through this major pain, and could shed some light on how they fixed it, or better still, if someone could point me in the right direction of how to fix it. I know that its not configured correctly, but where do I start to learn how to fix it? Regards, Abraham -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Andrew Lunn Sent: Tuesday, 29 November 2005 7:16 PM To: Abraham Celik Cc: [EMAIL PROTECTED] Subject: Re: [ECOS] Flash problem with Intel P30 On Tue, Nov 29, 2005 at 06:31:23PM +1100, Abraham Celik wrote: > Hi Guys, > > I am using an intel 28f256p30B flash on my ixp425 board. I get the > following upon boot up: Is this the normal flash device for that board? The source code for the ixpd425 says it should be a 28F128. My guess is that your flash device is being wrongly identified, or the configuration parameters are wrong. You need to take a close look at the hardware specific part of the flash driver in packages/devs/flash/arm/ixp425 and the generic intel strata flash driver in packages/dev/flash/intel/strata. Andrew -- Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss -- Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss
