Thanks for your reply Tom. I was able to download the same file as you: "configtool-060710.exe" from http://www.ecoscentric.com/devzone/configtool.shtml
However, following the rest of the instructions on building wxwidget( in order to ultimately rebuild eCos config) I am having a problem with. I see some strange make errors. In fact they are the same errors found by another: http://sourceware.org/ml/ecos-discuss/2006-06/msg00061.html There was no posted reply to this e-mail. How where you able to rebuild the eCos config tool? Thanks, -Ray -----Original Message----- From: Tom Malcolmson [mailto:[EMAIL PROTECTED] Sent: Thursday, September 28, 2006 2:53 PM To: Ray Duran Cc: [email protected] Subject: Re: [ECOS] Trouble with eCos Config Tool Ray, I too have recently started with eCos. I tried running configtool on cygwin but it did not work. Like you, I looked into it and found that this is apparently a problem with newer versions of cygwin. In the end, I found the page that you referenced, and downloaded the updated tool on this page. I think this is called "configtool-060710.exe". This works for me. http://www.ecoscentric.com/devzone/configtool.shtml I take it that, though the above web page says that configtool is a wxWidgets app, it is only partially so and still relies on unix calls for which it needs cygwin. Tom. Ray Duran wrote: > Hello, > > I am a new to the eCos community. > > I followed the commands on the eCos webpage > > wget --passive-ftp ftp://ecos.sourceware.org/pub/ecos/ecos-install.tcl > > Then invoked installation tool > > sh ecos-install.tcl > > I followed the commands but did NOT select pre-built GNU toolchain as I > had already > Downloaded a pre-built GNU ARM toolchain. > > After selecting a mirror-site everything seemed fine and I got a > installation complete message. > > So, I thought my next step was to launch the configtool by invoking > configtool.exe, but nothing happens. > > I did a little research on the mailing list and saw some sort of related > problems that say building the > Config tool is "tricky" and that there are known problems when running > against Cygwin 1.5.10 or later( which > applies to me). What am I missing? The procedure outline in the link > http://www.ecoscentric.com/devzone/configtool.shtml > seems to reference the CVS version. Is there a problem invoking the > Config tool with the non-CVS release? > > Any help or tips greatly appreciated, > > Regards, > > -Ray > > Ray Duran > Altera Design Specialist > Future Electronics > 2220 O'Toole Avenue > San Jose Ca. 95131 > 408 232 1478 > [EMAIL PROTECTED] > > The information in this transmission contains information that is > confidential and is intended only for the use of the individual or > entity to whom it is addressed. If the reader of this message is not the > intended recipient please delete it and immediately notify the sender. > > If the purpose of this transmission is to provide a quotation or to > confirm or acknowledge an order or to provide information in relation to > the Products and Services offered, unless otherwise agreed in writing, > the FUTURE ELECTRONICS TERMS AND CONDITIONS OF SALE exclusively govern > the sale of Products and the provision of services by Future Electronics > Inc. and its divisions, subsidiaries and affiliates and take precedence > over supplemental or conflicting terms and conditions to which notice of > objection is hereby given. The FUTURE ELECTRONICS TERMS AND CONDITIONS > OF SALE are available at www.futureelectronics.com and may be provided > on invoices, packing slips, order acknowledgements or other method. > > > > > > > -- Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss
