On 05/31/2011 11:45 AM, jayant biswas wrote: > Hello! > > I am using a STM3210E eval board > (http://www.st.com/stonline/books/pdf/docs/14220.pdf) and have > successfully configured ecos to use the SPI interface. I can run the > loopback test, which confirms its functionality. I would like to use > the SPI interface (connected to the SPI flash on the board) to > communicate with a programmable potentiometer (AD8400) that I have > mounted on the QST connector of the evaluation board. I have chosen > the pin PA8 for CSn. How can I make the SPI driver in ecos to use this > pin as the chip select? > > Thank you in advance for your help. > > Jayant > Set CYGHWR_DEVS_SPI_CORTEXM_STM32_BUS1_CS_GPIOS to 8 if you are using SPI1. For SPI2 or SPI3 set CYGHWR_DEVS_SPI_CORTEXM_STM32_BUS2_CS_GPIOS or CYGHWR_DEVS_SPI_CORTEXM_STM32_BUS3_CS_GPIOS accordingly.
Regards, -- Ilija Stanislevik SIvA doo ul. Mladinska 43 lok. 6 p.f. 53 MK-2400 Strumica Macedonia www.siva.mk <http://www.siva.mk> -- Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss
