On Fri, 2006-04-28 at 10:03 -0700, Jay Foster wrote: > I don't understand what it is you are asking for. Can you be more specific?
Rather than have these items set by CDL only, I think they should be set when the PHY is initialized by the ethernet driver. For example, I have hardware which may have any selection of 1000Mb (Gigabit), 100Mb or 10Mb devices and a single CDL selection is not adequate. If we are to change/add to the PHY layer support, it only makes sense to do so in the most flexible manner. > -----Original Message----- > From: Gary Thomas [mailto:[EMAIL PROTECTED] > Sent: Thursday, April 27, 2006 4:48 PM > To: Jay Foster > Cc: eCos patches > Subject: Re: Generic Ethernet PHY Driver Patch > > > On Thu, 2006-04-27 at 11:35 -0700, Jay Foster wrote: > > Attached is a patch for the generic ethernet PHY driver that adds the > > capability to configure the PHY speed/duplex. > > I would much prefer for the chosen speed/duplex to be passed in > when initializing the PHY and/or add a new call. I have many > systems where one configuration does not fit all devices. > > Could you rework your changes to have this flexibility? > > Thanks > -- ------------------------------------------------------------ Gary Thomas | Consulting for the MLB Associates | Embedded world ------------------------------------------------------------
