http://bugs.ecos.sourceware.org/show_bug.cgi?id=1000740
--- Comment #10 from Sergei Gavrikov <[email protected]> 2009-05-05 20:31:07 --- (In reply to comment #8) > So far, I have seen output from the "tuidemo" and "firework" demos. I can > navigate the menus and the fireworks are recognisable. > > Sergei, correct operation of the demos seems to be dependent on resetting > minicom between each demo. Otherwise, no output is observed. Have you seen > this > behaviour? I re-checked it again on olpce2294 in a batch mode as for i in install/demos/* ; do arm-eabi-gdb $i ; done Minicom had been opened in a separate tab as `minicom -o -c on' (ANSI mode, Status line is disabled) and I had not seen your issue. Well, just now I used the latest package version. Then I re-run all as you: `minicom -o' (VT100, Status line is enabled). Of course, no colors, but also no issue with a redrawing on _my_ target. I attach my mini.ecm for a reference (SERIAL0 -- my GDB port, SERIAL1 -- PDCurses port). -- Configure bugmail: http://bugs.ecos.sourceware.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the QA contact for the bug.
