Michael:
Thanks for your help. The solution was to use Document (Start) at
header, so when you reject it will reject from Header down..
Thanks again,
WDM
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, February 13, 2001 5:51 PM
To: Mojica William-FWM008
Subject: RE: Harbinger workbench - Document Reject
You may need to add the Document (Begin) and Document (End) mapping commands
to
your map (like a normal app to X12 outbound map). You may also need to use
the
ANY2ANYL envelope tables (ANSIOUT2 with the writes deleted). This should
also
give you document logging capability.
_____________________________________________________
EDI-Mike
Michael Taylor
EC Specialist
Banctec - Corporate Information Systems
(972)982-2815
-----Original Message-----
From: Mojica William-FWM008 <[EMAIL PROTECTED]> at Internet
Sent: Tuesday, February 13, 2001 5:15 PM
To: [EMAIL PROTECTED] at Internet
Subject: Harbinger workbench - Document Reject
all:
I have an app2app map and in there I have an "If data is missing
then document reject". The document stops but the data that has been written
before the reject goes to the output file rather than to the recovery file,
how do I tell it to REJECT the WHOLE DOCUMENT...the entire file to the
recovery file...
Document reject acts as a Document end. Remember this is an app2app
not a app-2-X12.
Thanks,
William D. Mojica
[EMAIL PROTECTED]
Order Services Dept.
EDI Specialist
Motorola, Inc.
Phone: (561)739-2852
Ext. 2852
Two Way Pin# 7392852
=======================================================================
To contact the list owner: mailto:[EMAIL PROTECTED]
Archives at http://www.mail-archive.com/edi-l%40listserv.ucop.edu/
=======================================================================
To contact the list owner: mailto:[EMAIL PROTECTED]
Archives at http://www.mail-archive.com/edi-l%40listserv.ucop.edu/
